Bayyery indicator light

1. Turn the ignition to run (one position before starting engine).
2. Use a paperclip to push and hold the RESET button for 5 seconds. The CHANGE OIL SOON indicator flashes to indicate the system is reset.
3. Turn the ignition off and start the engine to verify the indicator has been reset.

May 2, 2020

1991 BUICK Park Avenue Maintenance Light ... - Oil Reset

Make sure the tail lights and brake lights are working including the one in the rear window, if any of these are out the dash warning light will stay on, any bulbs that look discolored should be replaced

Here you go:

You can find the oil life monitor reset procedure here

Oil Change Light Reset BMW Z3 1998 1999 2000 2001 2002 Reset Your Oil...

it does, but you should always check with a tester. they had a problem with the eye changing before the bayyery was bad.

set the mileage when the odometer is showing. put the key to off position. press and hold the reset button then turn the key to on position, do not start. then continue holding the reset button until the reading stops to zero or blank. turn it off, that should reset the light indicator

Try routing a jumper cable to the starter terminal where the battery cable goes to & then hook it to your positive bayyery connection. Then try to start it. If nothing happens you have a bad ground connection

From what I remember with my Mighty Max '90, if you remove the dash panel , the one with the cluster gauges, you will find a push button that resets the engine maintenance light. It's a thing that wont reset by itself and lights up at specified mileage that is reached by the odometer. Usually the mechanic that does the work indicated by the light will reset it when the work is done. The red light might indicate a serious problem, so before you ignore the possible problems it might indicate, eliminate the the serious ones before you reset. The trick is to get the dash panel off.

what is the procedure you are using can you explain it to me?
Resetting Procedure

To reset the CHANGE OIL SOON indicator if equipped with the Driver Information Center (DIC).

1. Turn the ignition to ON without starting the engine.
2. Fully press and release the accelerator pedal three times within five seconds.

• If the CHANGE OIL SOON indicator flashes two times, the system is resetting. Turn the ignition key to OFF then start the vehicle.
• If the CHANGE OIL SOON indicator comes on and stays on, repeat the procedure.

To reset the OIL LIFE indicator if equipped with a Trip Computer.

1. Press the trip MODE button until the light appears next to OIL LIFE.
2. Press and hold the trip RESET button until the oil life percentage changes to 100%.

Hope this helps Ill look into the ABS lights but I do believe that you will need a scan tool to retreive a code to be able to diagnose the reason for the lights

Make sure you check the spare tire too; had this problem on another model and the dealer said it was the spare which is also monitored.  Good news in case you need it one day.