Question about 2007 Pontiac Aztek

1 Answer

Aztec bcm im replacing the bcm, i was wondering if i can drive to dealership after replacing it. will driving it f up the new bcm, or will it even start?

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 59 Answers

The truck will not start if the BCM is repalced but not programmed. The theft system will prevent it for several reasons.

Posted on Oct 06, 2008

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Skid control engages when I barely turn my 2002 Toyota 4runner. The dealership said that I needed to replace the Yaw Rate Sensor and it will cost $800.. Can I just remove the bad Yaw Rate sensor and drive...


love new cars yet..

are you in 4wd? what road?????????????????????

did you read the operators guide yet, if not why not.?

$800 might be a motivation, no?



in my manual (2008) tells how to turn off most of these magic technology\'s. mine has 5 magic. ABS , yada, yaha bla...

so turn them all (most) off, some go to 1/2 measure, RTM !!!

in fact ,mine tells me, when driving in DIRT>

do X,Y,Z (defeats) (dash buttons on mine)



did you read that yet? so do that. put it in DIRT mode and see

if all above goes away..

i cross fingers for you .

why not next time, post road surface conditions with post.

Im on dirt. in 2wd or 4wd? or or or.

im on ice

im on dry pavement.. ... we just cant guess. that. and is paramount to the solutions.



my car has 4wd and one mode is virtual LSD

where the PCM/BCM/ABS uses brakes to simulate LSD

very very nice on ice the rest i hate.

this magic mode, makes all 4 wheels pull at once. on ice.

like poor mans AWD, unlike my old part time 4wd.

i used to do this TRICK with my brake foot, not its automatic.

but i dont need it, I still can use my foot.

Jan 06, 2014 | Toyota Cars & Trucks

1 Answer

Installed a new radio in a 2004 PT Cruiser, now interior lights and radio wont come on...everything else works


new radio has to have play code dealership has to reprogram new radio to bcm since interior lights and radio part of the bcm.

May 08, 2013 | 2002 Chrysler PT Cruiser

1 Answer

1998 Altima dies wile driving then wont start back up


Have you checked your "knock sensor" or cam sensor? It tracks cam and or crank movement for timing.

Jul 26, 2012 | 1998 Nissan Altima

1 Answer

While driving Down the road sometimes the lights would turn off while switching from brights to dims and now we no longer have no dims at all just brights.


I had a similar problem with my 2002 chevy impala, it was the BCM Module, Costed about $680 to replace it from the dealership, the Dealership has a special tool to replace the old BCM because it has your car information and it has to be put on the new BCM.

Dec 04, 2011 | 2002 Chevrolet Impala

1 Answer

Have 2001 aztec secuirity mess in panel and dont work windos please help me tnks


you may want to have your BCM tested at a dealership or garage. if you do have it replaced, try as much as you can can to have a dealership reprogram it for you. there has been a lot of reports of garages reprogramming the new ones and they will mess up still.

Jun 30, 2011 | 2001 Pontiac Aztek

1 Answer

How do i fix my 2003 impala the speed ometer says im going 70mph when im not even moving, and when im driving it reads 120 mph when im clearly only doing about 30mps , i only have 29000 miles


Hello: Sir the electronic cluster has failed. You will have to go to a GM dealership They will have to order you a replacement cluster. After the new cluster is installed it will have to be programmed with a gm scanner.

Dec 03, 2010 | 2003 Chevrolet Impala

3 Answers

My locks quit workng is there a setting or fuse?


same prob pull fuse IOD out and put it back in place .I have to do this about every week . Also lights turn off when driving.Piece of junk.Also belt rattle. Good luck
Jerry

Jul 28, 2010 | 2005 Dodge Grand Caravan

1 Answer

My 2001 oldsmobile Alero security shuts down. I


unfortunately the passlock system in gm cars is garbage and has many hiccups replace the battery and the system has to relearn every thing i have replaced the body control module and that has helped me i only experience a no start about every 20 times or so the bcm is under the glove box what i found was that when it rained hard and long my car had multitudes of problems i pulled it(bcm) and discovered that where it was located if the blower motor box drain hose was clogged it would leak into the bcm and short it out it has also put my rds stereo in locked mode and cant be unlocked unless you have a tech 2 scanner(go to the dealership bend over and pay,they might even be able to unlock it for you maybe
so i have a 17,000 mile car with a great nonworking stereo and the dealership doesnt have a clue im glad we bailed these robbers out so they could screw us some more its not just oldsmobile it is a gm problem on most of their vehicles id rather have a yugo gm owes us the courtesy of at least being able to fix their product or replace it i will never own another gm car i have a honda with 240,000 mile on it and a toyota with 125,000miles and never such lame excuses for a car sign me .....foreign owner for life(by the way do you really think that your gm is made here guess again gm execs(robbers)drive imports paid for by us morons

Dec 29, 2009 | 2007 Chevrolet Tahoe

1 Answer

What can i do about the security problem and stalling?


HAVE YOUR CAR HOOK UP TO A DIAGNOSTIC SCANNER TO SEE WHAT CAUSING THE CHECK ENGINE LIGHT TO COME ON.IF YOU ARE HAVING SECURITY PROBLEMS THE DEALERSHIP HAS TO FIX IT.SOME TIMES YOUR IGNITION KEY OR LOCK CYLINDER IS WORN WHERE THE BCM AND PCM DONT RECOGNIZE IT.THINKING ITS A THEFT CAUSING CAR TO SHUT OFF.SEE THE DEALERSHIP HAS TO SEE IF YOUR KEYS IS WORN TO A POINT WHERE THE BCM AND PCM.DONT RECOGNIZE. THE IGNITION KEYS.SO THEY HAVE TO REPLACE THE KEYS ALSO IGNITION SWITCH AND BCM.THEN THEY HAVE TO REPROGRAM THE NEW KEYS AND IGNITION AND BCM TO THE PCM SO THE CAR WILL CRANK UP.THIS IS A DEALERSHIP FIX.

Sep 18, 2009 | 1999 Oldsmobile Alero

1 Answer

What is the drive cycle for an 01 pontiac aztec?


if there is really no problem with all these things they should be able to clear out the lights when they go to do the inspection.

Mar 10, 2009 | 2001 Pontiac Aztek

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

676 people viewed this question

Ask a Question

Usually answered in minutes!

Top Pontiac Experts

yadayada
yadayada

Level 3 Expert

70387 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22041 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6880 Answers

Are you a Pontiac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...