Question about 1982 Porsche 911

1 Answer

Porsche 911sc 1982

Wiring to light switch to indicator

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Scholar:

    An expert who has written 20 answers of more than 400 characters.

  • Expert
  • 132 Answers

These guys mark or arther at exoticars 97370311 will help with any info on any 911 highly recommended

Posted on Nov 09, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

1982 porsches 924 no spark to starter and no head light


Your battery is probably shot. Try replacing your battery.

Aug 01, 2012 | 1982 Porsche 911

1 Answer

1981 3.0L Porsche 911SC engine installation


If you have alignment dowels on either the block or trans., this could be blocking the road. Make sure that the input shaft is properly lined up with the pilot bushing. This will be a snug fit and must go in straight.

Jun 20, 2008 | 1982 Porsche 911

1 Answer

911SC 1982 transmission will not shift into 1st or 4th gear


Your Synchro is worn, time to replace all of them, just take it to a transmission shop. The part is quite expensive but the new ones should last longer than the original factory part. I had a 82 Turbo n mind as well replaced them all since both 1st n 4th already worn.

May 10, 2012 | 1982 Porsche 911

1 Answer

Porsche parking brake light and convertible top


you should be able to get to the ebrake switch by the e brake lever. If you can, to get top up you can cross the two wires going to the switch together and get the top up normally with switch. If this turns the parking brake indicator on on the dash, then order yourself a new switch and replace.

Mar 18, 2012 | 2001 Porsche 911 Carrera

1 Answer

1978 Porsche 911SC Cold start with correct tick over of about 800 rpm. Almost immediately however rpm increases up to a tickover speed of about 2800 rpm. This rpm is sustained continuosly up to and...


hello there
can you check if your distributor advance plate is free of movent?
Or your vacuum hose for advance is working(the one on the right)Check your timming as well.it is 5 before tdc.
Check this out and get back to me with an email
Seems like your idle get stuck on high rmp right?
Let me know what do you mean tick over?
proporsche@yahoo.com

proporsche

Mar 26, 2011 | Porsche 911 Cars & Trucks

1 Answer

Speedo nylon cog replacement?can you help me.the teeth on the cog has worn out...porsche 911sc 1982


hello there
would you tell me what do you mean by cog..
i can help with all the problems

proporsche@yahoo.com

proporsche

Mar 05, 2011 | Porsche 911 Cars & Trucks

1 Answer

1980 Porsche 911SC Problem #1. Cuts out on freeway, then engine will start again after between five seconds and a minute Problem #2. After parking for a short while the engine will start, but dies...


Check for a intake hose leak between your mass air flow sensor and the intake manifold. Porsche refers to this piece as a vane air flow sensor.

Apr 01, 2009 | 1982 Porsche 911

1 Answer

Indicators


mark from exoticars will help 97370311

Jul 11, 2008 | 1982 Porsche 911

1 Answer

82 911sc


Check your spark plugs, fuel filter and fuel pump. Basically car needs spark and fuel to remain going. Check all those and replace when necessary.

Jun 16, 2008 | 1982 Porsche 911

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

316 people viewed this question

Ask a Question

Usually answered in minutes!

Top Porsche Experts

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

yadayada
yadayada

Level 3 Expert

60769 Answers

Dave  C
Dave C

Level 3 Expert

1050 Answers

Are you a Porsche Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...