Question about 2002 Toyota Camry

1 Answer

Foglight Switches We had an accident that ripped off the entire front bumper. After replacing everything we had foglights installed by mistake from the repair place. My question is, I have the foglights and everything wired in correctly but no switch to turn them on. Is there any way I could add in an aftermarket switch to turn them on? Any switch would work, even a normal toggle switch, just so I can get them on.

Posted by on

  • core2kid Sep 30, 2008

    How would you do that? Is there any diagram?

×

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 6 Answers

If you wired them into the factory harness, then you will have to add a factory switch. however you can wire an aftermarket switch directly to the foglights, bypassing any factory harness

Posted on Sep 30, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do I replace the front foglight lamp on a Citroen Xzara Picasso?


Jack up front; remove road-wheel (support Picasso on axle stand).

Remove two large torx screws on lower edge of bumper and peel back wheel arch liner (wedge behind hub).

Remove small torx screw holding black plastic support piece below lamp.

Remove 4 torx screws on holder surrounding lamp, pull back holder and support piece and lift out lamp (minding hands on broken glass)

Note that the body coloured bezel will try to fall outwards at this point.

Fit new lamp and push bezel in at the same time.

Refit all screws in reverse order, refit wheel etc.
(Total time 25 mins)

Mar 27, 2015 | Citroen Cars & Trucks

1 Answer

Foglight Wiring Broken


We have no wiring diagrams so I suggest you ask the dealer for a detailed cost breakdown to see why they want such a large amount of money to fix this problem. Seems very high and I am a retired dealer technician.

Mar 24, 2014 | 2006 Toyota Corolla

1 Answer

How to install a foglight of an MPV DX 2001?


The headlight low beams must be on for the fiog lights to operate.

Oct 26, 2012 | Cars & Trucks

1 Answer

Citroen Xantia fog and reversing lights not working


Check Fuse F3. It supplies 12v to the reverse switch located on the transmission. If auto transmission (4HP14) the switch will have 4 pins, 2 for reverse light, 2 for starting circuit. If manual, it has two pins. When gear is in other position, only one pin will have 12v. When gear is in R, both pins will have 12v. The 2nd pin supplies directly to the reversing light. Fog light has connectors behind the bumper. It tends to get corroded. Disconnect and clean both side of the connectors and retry. Some may get the wires snapped. Check there first. Fuse F18,F7 and F6 supplies 12v to the foglight circuit. F6 supplies to the foglight relay. Check the relay too.

Apr 05, 2012 | Citroen Xantia Cars & Trucks

1 Answer

Renault scenic front foglight bulb


I found the easiest way to change the fog light bulb is to take bumper off, takes 5 mins, 5/6 screws/clips across the top were the bonnet meets the bumper and a few clips on wheel arches then pull off and 2 spot lights very easy to Accra.

Mar 31, 2012 | 2003 Renault Renault Scenic 1.6

1 Answer

Foglight does not go on how do I replace bulb


u must get under the front bumper, the fog light bulbs are replaced from the back, do not touch these bulbs when installing ot they will crack the 1st time u trurn the fogs on for more than a few minutes

Apr 22, 2010 | 2005 Dodge Neon

1 Answer

Verona 2005 fog lights won't work. Fuses are ok, lightbulbs are ok. Fog light switch lites.


Remove the entire foglight assembly check for a loose wire inside the assembly. I had the same problem on mine but it only affected one of the foglights. Also check with a test light at the connector where it connects into the foglight assembly. Also make sure foglight bulbs are properlly tighted.

Dec 08, 2009 | 2005 Suzuki Verona EX

1 Answer

2009 camry foglight replacement


get replacement lamp assemb. dissconnect plug from lamp remove attach hardware and reninstall new lamp royedwardtat

Aug 28, 2009 | 2007 Toyota Camry

Not finding what you are looking for?
2002 Toyota Camry Logo

Related Topics:

254 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

61292 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...