Question about 2000 Oldsmobile Intrigue

2 Answers

A/c only blows on the passenger side heat comes from driver side

2000 olds intrigue i think it is a bad sensor but dont know where it could be to replace it

Posted by on

  • stg068 Oct 08, 2008

    DrCool.... can you offer any advice as to where the sensor is located?

  • francis rivero May 11, 2010

    did you just replaced or remove the battery of the car? does your a/c a climate control?

    tnx 4 using fixya,




2 Answers

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Thanks...where are the actuators located? do you know where I could see photos of this part so I can identify them?

Also, do I need to check for clogged lines? not sure if I mentioned previously or not, but the floor on the passenger side was really damp one day this summer... like I had left a window open, but I hadn't.

Thanks guys...

Posted on Oct 29, 2008


Its your actuator there are two lh and rh or your hvac control it sounds like let me know if you need help

Posted on Oct 25, 2008


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

2 Answers

2000 dodge durango

I assume this truck has daul zone heating and a/c, the air blows but is not hot? if this is the case then you may have dissconnected the blend door actuator or it just went bad. this is common that the actuator goes bad,
there are two seperate actuators that control the hot/cold door in the heater box this way the passenger and driver can set there on temp.
the actuator for the drivers side is locted on the drivers side under the dash on heater box, the blower is on the passenger side , you can check connections but i do not think it is that but rather the actuator.

Jan 16, 2013 | 1999 Dodge Durango

1 Answer

We have changed the heater core,,, and thermostat.. it is still blowing cool air... i bought the coolant temperature sensor but dont know where it goes is it behind the dash board also?

Hi I have a 2002 JGC ltd and it is most likely your dampeners or louvers located behind your dual temp controls for driver and passenger sides that control the direction of air flow from air outside in, circulation, heat to windshield, centre and or to floor etc. I had a friend that had heat only to the passenger side and cold air blowing to driver side. He took it in and they replaced stuck dampeners and it was not cheap. I also had a 98 JGC ltd with the (coolant sensor is bad) warning coming on at least 4 to 5 times in a day and had heat. My problem is that my interior glass was fogging up, used glass defogger and stop leak. The problem was fixed but I still smell antifreeze because of the leak and it is irritating me. I may consider replacing the heater core and was wondering if you took it in or did it your self and how did you do it if you replaced it yourself, plus how much did it cost you?


Nov 10, 2012 | 2000 Jeep Grand Cherokee

1 Answer


the blend motor for the passenger side

Oct 29, 2009 | 2000 Oldsmobile Intrigue

1 Answer

Climate control only blows cold air driver side, i get heat on passenger side however

This sounds like a "dual-zone" issue. Does this car have this feature. If so, probably one of the temperature sensors. Should be located under the glovebox by the passenger leg area.

Oct 18, 2009 | 2002 Oldsmobile Intrigue

1 Answer

2000 oldsmobile intrigue the AC blows some what cool on drivers side and blows ice cool on the passenger side

Two things could be the problem.One is the freon could be low.The other is a actuator motor that controls the temp door for that side is not closing the door all the way.If it is the actuator motor,then it could be a job for a mechanic to do,it can be hard to repair,labor wise.If I can help let me know please,but check freon first,this can cause the problem also.

Aug 23, 2009 | 2000 Oldsmobile Intrigue

1 Answer

A/c blowing hot on one side and cold on other

Bad servo ,you have to go under dash to replade.

Jul 30, 2009 | 2000 Oldsmobile Intrigue

1 Answer

Ac system

take the dash off to see if the vents are connected to the dash. if not, the heat from the engine is blowing through the open hole

Jun 16, 2009 | 1998 Oldsmobile Intrigue

1 Answer

Air conditioning not working on driver side

sounds like one of the mixing doors on the drivers side is stuck on the heater side. or the vacuum hose on the mixing door is off of not creating enough vacuum because of a crack in it or possibly coming off

May 27, 2009 | 1999 Oldsmobile Intrigue

1 Answer

Air only blows cold on the passenger side of my olds intrigue....heat on driver side

All I did was recharge mine to the correct level of refrigerant and it was fine after! hope this helps!

Apr 26, 2009 | 2002 Oldsmobile Intrigue

Not finding what you are looking for?
2000 Oldsmobile Intrigue Logo

Related Topics:

110 people viewed this question

Ask a Question

Usually answered in minutes!

Top Oldsmobile Experts


Level 3 Expert

77194 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8743 Answers

Are you an Oldsmobile Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides