Question about 2008 Honda Pilot

1 Answer

Replace the face skid in the front bumper

I have a 2008 pilot with a damaged front bumper face skid. That is the bottom center plate of the front bumper. Computer illustrations shows the part is removable. My questions are: Do you have to remove the front bumper to replace this part?, Is it a two men job?, Is the part mounted to the front bumper by hanging hooks and secure with two tapping screws?.

Posted by on

  • Anonymous Mar 13, 2014

    how do you replace the front bumper for 2008 toyota tacoma

  • Anonymous Mar 21, 2014

    Front bumper replacement

×

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 27 Answers

Remove front bumper and it should be clear what holding the face skid in place

Posted on Nov 07, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do I remove front bumper of Yukon XL 2003?


Try removing the skid plate from under motor then that should allow you to access the bumper bolts. Some of them required removing the grill also. Good luck

Jan 29, 2015 | GMC Yukon XL Cars & Trucks

1 Answer

Location of oil filter


The 2007 Tundra 5.7l engine doesn't have a spin on filter - it uses a replaceable paper cartridge within a permanent housing. Located under the skid plate on the front-left portion of the engine, the oil filter unit has two coolant hoses, a black plastic screw-in housing, and a large, metal, round screw with a 1/2" square fitting in the middle of it. The cartridge-type oil filter is in the housing.

If equipped with a skid plate, access is accomplished by removing the 5 skid plate bolts, allowing the plate to swing down on integrated hangars (with the front plastic bumper skirt still attached). To completely remove the skid plate, three small screws holding it to the front plastic bumper skirt must also be removed.

Toyotafilter kits contain a new filter cartridge, a plastic drain plug, and two O-rings. The drain plug is used to drain residual oil from the filter unit prior to removing the plastic screw-in housing. After removing the large, metal, round screw with a 1/2" square fitting in the middle of it, the plug simply snaps into the bottom of the plastic housing. The smaller of the two new O-rings replaces the existing O-ring on the screw.

Once drained, the plastic screw-in filter housing is removed using a filter wrench (Toyota special service tool). The larger of the two new O-rings replaces the existing O-ring on the screw-in housing. VERY CLOSE ATTENTION must be paid in placing the new O-ring - failure to properly seat the new O-ring could result in a massive oil leak! The filter itself is currently only available from Toyota.

Aug 15, 2010 | 2007 Toyota Tundra

3 Answers

My hyundai Santa fe is leaking transmission fluid somewhere at the front of the engine. I can't see it because of the skid plate. Any ideas of what it could be?


Good Evening. Unfortuantely there is no easy path to a right answer here without removing the skid plate. In front of the engine are transmission cooler lines and other miscellania. The best advice i could give you is take down the skid plate and have a can of brake cleaner handy to clean everything off while you have it turned off then have someone turn it on for you so you can visually see where it is coming from. Hope this helps and if you have any more questions feel free to ask.

Aug 14, 2010 | 2004 Hyundai Santa Fe

1 Answer

Where is starter for 2001 VW Beetle turbo?


The starter is at the front of motor bottom of car directly behind radiator. You will need to remove the skid plate and go about 12 inches back from the bumper while under the car. The starter is a cylinder shaped and mounts to the bottom of the block in front of the oil pan.

Jun 05, 2010 | 2001 Volkswagen Beetle

1 Answer

I need info on how to replace the headlamp bulbs on my 2008 Chevy Malibu, can you help.


The procedure is very involved.It requires the removal of the front bumper fascia fasteners from the center and side of the headlamp to be removed.
  1. Remove the front bumper fascia fasteners from the center and side of the headlamp to be removed, full removal of the fascia is not necessary. Refer to Front Bumper Fascia Replacement.
  2. Gently pull the fascia forward to allow clearance to remove the headlamp assembly.
  3. You will also need to remove some of the fasteners at the front of the inner wheel well.
  4. The Front Bumper Fascia is the plastic cover over your front bumper.
  5. You may also have to remove the plastic cover that is located under the front of the hood over the radiator.It extends to both sides.

Oct 27, 2009 | 2008 Chevrolet Malibu

1 Answer

How to remove oil filter from 5.7 l tundra engine


you have to remove the front skid plate located at the front of the truck underneath the bumper. It's the big metal plate.

Oct 13, 2009 | 2000 Toyota Tundra

1 Answer

Replacing the skid plate on 07 Tahoe Z71


Remove bumper or use a swivel adapter to remove

Apr 29, 2009 | 2007 Chevrolet Tahoe

1 Answer

Oil change on a tundra


No special wrench needed for filter.
The oil filter is located in the front of the engine on the right side, down at the bottom.
It's easier to change the filter by taking of the front skid plate underneath. You'll need a 12mm socket to take it off.

If you try to get it from the top, you'll get oil all over the skid plate and have a big mess to clean up. Plus, you may damage the radiator by leaning on it.

Apr 16, 2009 | 2007 Toyota Tundra

1 Answer

Add front license plate, do I need to remove bumper to get behind


try using self tapping screws so you dont have to remove it, you can drill pilot holes if the screw wont go thru easy, and you dont need a nut/bolt

Mar 20, 2009 | 1998 Honda CR-V

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

703 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

yadayada
yadayada

Level 3 Expert

61168 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...