Question about 2004 Honda Accord
Just re built blown engine and now wont start,has been running but 99 times out of 100 it starts runs for 1 or 2 seconds and stops,cleared all fault codes and tried to re start and then checked codes againn and it said cam position sensor so I replaced the sensor and still wont start.It has got the eml light on and after the sensor has been replaced now the glow plug light is constantly flashing ....on the couple of times we have managed to get it going it seems to run well and has been driven for a few miles with no problems......it just wont normaly start at all !!!!!
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
SOURCE: Check engine and d4 lights on
d4 is flashing as a trouble code for the automatic transmission... i would say without research that it is a code for a transmission solenoid. maybe while washing the car some water got in and caused a short...these solenoids are usually weatherproof....you could try disconnscting the battery for 30 secs..to clear the trouble code and then start the car. remember you may lose your preset info!
Posted on Oct 28, 2008
SOURCE: Transmission shudder
I had a similar problem on my 93 Accord after I accidentally threw the car in reverse at 50 mph, obviously wrecking the transmission. When I got it rebuilt I was told the transmission pump was to blame (clogged with "shrapnel"). I, and your car manual, recommend taking the car in to get the tranny looked at. Especially considering you just had the fluid changed which is what would normally cause the problems you are describing.
Posted on Nov 15, 2008
po505 idle air control if this is the code all hondas do it eventully, small problem easy fix u have 2 choices either remove the idle air control motor and clean the inside of it u will find it's black and the spring inside is stuck clean it with carb cleaner or gum cutter any parts store will have this it's a dirty job it will work for awhile but to replace it is recommended its not expensive for a new one which u can get at any autoparts store autozone,advanced,napa etc. there is only 2 bolts in most cases maybe 3 i doubt it though if u go online t google and type in th eyear make and model and engine size in ur case it's a 3.0 v6 and look for idle air control locations u'll find it to do this job a shop will charge u anywhere from 100.00 for diag to retrive the code plus the part and the labor so about 250.00-375.00 it will only take u honestly maybe 15 minutes to perform only tools needed are a 10 millimeter wrench there is only 1 connector to disconnect and ur done if u do this u will still have the check engine light because u have not cleared it from the computer to do this just disconnect the negative battery terminal (the black one or has a neg sign - don't disconnect the positive side +)for 5 minutes then reconnect and the computer will have reset no more light. good luck it really is that easy
Posted on Oct 10, 2009
Tips for a great answer:
Jan 02, 2016 | 1999 Honda Accord
on Dec 07, 2009 | Honda Accord Cars & Trucks
Dec 05, 2013 | 1991 Honda Accord
Aug 23, 2013 | 1991 Honda Civic
Mar 05, 2013 | 1994 Honda Accord
Dec 13, 2012 | 1994 Honda Accord
Oct 10, 2010 | 2005 Honda Accord
Jun 26, 2010 | 1993 Honda Accord
Jun 03, 2010 | 1991 Honda Accord
Mar 14, 2009 | 1988 Honda Accord 4 Door
109 people viewed this question
Usually answered in minutes!