Question about 1990 Ford F150

1 Answer

Thermostat 1995 ford f150

How does the thermostat go in

Posted by on

  • bender2010 Apr 04, 2009

    my truck has the same problem only its leaking coolint from the bottom and my truck is f150 94 ...but im not sure how the gasket is put on we have already gone throu two heads they both cracked

  • yadayada
    yadayada May 11, 2010

    POINTED SIDE OF THE T-STAT UP

×

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Ford Master
  • 1,779 Answers

'spring' side always toward engine (that's what heats up and expands (opens) as the engine warms up).countrycurt0

Posted on Sep 28, 2008

4 Suggested Answers

  • 255 Answers

SOURCE: Ford 1995 F150 Truck. Turn ignition key off but Truck still runs

ignition switch electrical portoin above brake pedal on steering column

shack

Posted on Apr 14, 2009

  • 1129 Answers

SOURCE: 1995 ford f150 4.9 how to remove a/c clutch

remove drive belt then aquire the clutch removal tool from Auto zone or Napa, there is a specific puller designed to remove this clutch,in some cases in order to hold the pulley while removing center nut or bolt you must use a chain wrench with an old leather belt wraped around the pulley to protect the v-ribs on pulley in order to get the pulley bolt or nut loose the clutch will just turn when trying to loosen center nut if you don't use the chain wrench to hold it, after removing said nut or bolt attach the puller to the clutch and while holding it stationary with the chain wrench proceed to turn the shaft of the puller to remove the clutch, it should pop free after a couple of turns with a socket wrench of the appropriate size. PS use the chain wrench ($22.00 Auto zone) only in the corerect direction it does not clamp effectively either direction. also sometimes there is special holding tool for certain clutches, consult Napa or the dealer before buying the chain wrench it may not be effective in holding the clutch while trying to remove center bolt.

Posted on Jul 08, 2009

Audioaholic
  • 376 Answers

SOURCE: 1995 ford f150 when I push the overdrive button,

cut wire/ or lost ground signal to switch

Posted on Sep 13, 2009

  • 5 Answers

SOURCE: my 1995 ford f150 v8 302 will not start

Ford truck was running fine then it just shut's OFF, afterwards did start once stayed on for a couple of minutes then shut off again. A friend thinks it's the computer after checking the car. Note I did pressure wash the engine 2 day's before and didn't use it till now.

Posted on Nov 24, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 1995 4x4 f150 & a explorer and nether temp guage will work? help


Hi!!

Look for broken wire or loose connection to water them sensor, usually located in the thermostat housing or very close by. If plug is tight and no visible wire damage present. Replace Temp Sensor.

Don't forget to rate this post!! Good Luck.

May 06, 2010 | 1995 Ford F150 Styleside Regular Cab

2 Answers

WHERE DOES CYLINDER 1 SPARK PLUG WIRE GO ON DIST. CAP FOR A FORD F150 1995 5.8L


For 1995 Ford F 150 4WD Pickup 5.8 liter V-8 VIN "H" check this...

36c2fec.jpg


Hope help with this (remember rated this).

Feb 06, 2010 | 1995 Ford F150 Styleside Regular Cab

1 Answer

1995 ford f150 won't start. battery is good. smell


Which engine is in this ? You may have dropped your timing chain

Feb 02, 2010 | 1995 Ford F150 Styleside Regular Cab

1 Answer

The heater in my 1995 f150 barely heats. I


Did you try replacing thermostat??

Jan 04, 2010 | 1995 Ford F250

1 Answer

My 1995 ford f150 v8 302 will not start


Ford truck was running fine then it just shut's OFF, afterwards did start once stayed on for a couple of minutes then shut off again. A friend thinks it's the computer after checking the car. Note I did pressure wash the engine 2 day's before and didn't use it till now.

Nov 08, 2009 | 1995 Ford F150 Styleside Regular Cab

1 Answer

Need to know where heat gauge sending unit is locatad on engine block of a 300 ci ford f150 is.


should be between the exhaust ports on the cylinder head, or int he intake manifold on the front of the engine near thermostat

Oct 29, 2009 | 1995 Ford F150 Styleside Regular Cab

1 Answer

Jack location for 1995 Ford F-150


I have a Ford 1995 F150, The jack is on the passenger side fender under the hood.
Hope this helps.

Jul 10, 2008 | 1995 Ford F150 Styleside Regular Cab

Not finding what you are looking for?
1990 Ford F150 Logo

Related Topics:

418 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

60867 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Fordexpert

Level 3 Expert

5331 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...