Question about 2008 Nissan Sentra

1 Answer

Power steering reservoir for 2008 Nissan Sentra 2.0 S

Where is the place to fill the power steering fluid on a 2008 Nissan Sentra 2.0 S? I do not see it anywhere.

Posted by on

  • Anonymous Mar 29, 2014

    2008 nissan sentra key fob / intelligent key doesn't work

×

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 2 Answers

I had this question initially. However, the Nissan Sentra (starting in 2007) has an electric Power Steering. It DOES NOT need any power steering fluid. The electric power steering is suppose to give you better fuel efficiency and lower maintenance cost.

Posted on Feb 28, 2009

  • Kenneth Cox Jul 21, 2013

    I need to know how to remove the steering wheel on a 1997 Nissan Sentra.

×

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where do I fined the filler to fill the power steering up


Usually there is a reservoir with a (black) cap that partially turns on/off. It may have a short dip stick attached to the underside of the cap for obtaining the correct fill level.
Look for smaller hoses that go down near the firewall and also to the power steering pump which has a belt that drives the pulley. The common point where the hoses meet will be the reservoir.

Nov 06, 2013 | 1996 Nissan Sentra

Tip

Power Steering Noise Grand Caravan & Town & Country


2001-2007 Models Do you hear your power steering wining. Been to the dealer saying "Its the pump going bad"......"System needs to be flushed, fluid is dirty" & my favroite "Your rack is bad". Folks 90% of the problems is the power steering reservoir filter. To change this filter you have to change the reservoir. The reservoir has 2 hoses attached to it, one small(return line), one large(exit/feed line). When the fluid returns to the reservoir through the small line into the reservoir & through the filter, back into the system. Filters get cloged. To change you will need. One NEW Reservoir $28 Chrysler Part # 4743012AA , buy this first looking at it explains alot. 2qts ATF 4 $11 to change the fluid in the system. Socket set with 6mm to 10mm & 4in extension, 1 channel lock to remove clamps on lines, flat head screwdriver. Old towels or rags, 1 turkey baster $1, 1 paint nipple or small ballon to fit over the small return line opening on the new reservoir(SEE PART #2!!!), 1 old clear washer fliud jug. To remove the reservoir sitting right on top to the drivers side. You will need a 2nd person for PART #2. Run car 10 min. to warm up the fluid & get it pumping through the system. Shut car off, put towels around the reservoir. Remove cap throw away. Using the turkey baster remove as much of the fluid as you can. Remove & slide the clamps back out of the way 6in. Remove lines fluid will come out of the lines. Remove the 2 bolts from the mounting bracket( DO NOT LOSE). Snap or cut the clip holding the 2 cable on the front of the reservoir. Looking at the new reservoir see the slot on the bottom, theres a 10mm bolt underneath. Use 10mm & extension, loosen the bolt only. Remove reservoir. When putting new one on DON"T PUT the RETURN LINE ON. Part #2 New reservoir in place???? Everything tight ,but not over tightened?? Remove some of the towels except under the return line area. Using the paint nipple place over the return line opening on the reservoir, this is important that the system retains presure. Smash the old washer fluid jub to place into the engine compartment up near the reservoir, DON'T LET TOUCH THE EXHAUST. Place the return line in the jug. Fill the reservoir to the top, but not into the neck. Place cap on reservoir. With a 2nd person starting the car for 3 or 4 seconds. Window or door open so they can hear you say "shut it off". Watch the fluid level drop in the reservoir, DON"T LET IT RUN EMPTY!!!! Holding the jug when doing this the old fluid will pump out of the system into the jug, you will be able to see this with the clear jug.. Repeat untill 1qt of fluid has been added to the reservoir & pumped through the system. Remove jug from car, empty the fluid into the empty AFT 4 bottle. Put jug back into place, repeat the Fill/Start/Shut off. Is the fluid running clean REAL RED into the jug, if not repeat till it runs RED. Remove paint nipple place line on quickly. Put clamp into place. Fill the reservoir to the top fill line. Remove all towels. Start the van, check the fluid level.Fill if needed. To bleed the system of any air that might have gotten in, with the car running turn the wheel all the way to one side & then the other without hitting the stops do this about 10 times. Check for leaks. Check fluid level. Your done clean up mess. Hope all your noise has gone away..... 2003 Grand Caravan ES by Chris

on Jan 23, 2010 | Dodge Grand Caravan Cars & Trucks

1 Answer

Fill 2008 nissan pathfinder windshield washer fluid


Just one.Check the lines and the pump at reservoir,

Jan 14, 2013 | Nissan Cars & Trucks

2 Answers

I cant find the power steering refill location....where the hell is the power steering thing. Can it be any more difficult to find..?


According to my service manuals the 08 Sentra has EPS or Electronic Power Steering and does not use any fluid or have a pump because it is an all electric system.

Jan 17, 2011 | 2008 Nissan Sentra

1 Answer

Where is the inhibitor relay on a 1996 nissan sentra


It's in the black box between the washer fluid reservoir & power steering pump on the left hand side of the engine. The box has the relays clearly marked.

Jun 26, 2010 | 1996 Nissan Sentra

1 Answer

How do you drain the power steering fluid in a 2006 nissan sentra


The reservoir can be pulled upwards out of it's holder. Pour into suitable container.

Feb 02, 2010 | 2006 Nissan Sentra

2 Answers

Where do i put the power steering fluid in a 1992 nissan sentra and where is the place to put the tranmission fluid


POWER STEERING PUMP IS USUALLY ON THE PASSENGER SIDE OF THE CAR . YOU WILL SEE FAN BELTS AND PULLEYS CLOSE TO THE FIR WALL YOU SHOULD SEE A CAP THAT SAYS POWER STEERING
THE OIL TUBE IS BETWEEN THE ENGINE AND THE FIRE WALL YOU SHOULD SEE A YELLOW TEE HANDLE OR A RING FOR YOUR FINGER THIS IS FOR THE TRANSMISSION. YOU MUST ALWAYS CHECK THE TRANS WHEN HOT AND RUNNING AND NEVER OVER FILL YOU WILL SEE SLASH MARKS ON THE STICK NEVER FILL ABOVE THE SLASH MARKS

Aug 15, 2009 | 1992 Nissan Sentra 4 Door

1 Answer

1996 Nissan Sentra Idles Roughly, Cuts Off, Engine Light Stays On


if this is an automatic there will be a dip stick if it is a manual you do not use transmission fluid to find out what sencor is bad take car to advance auto parts they have a digatal reader and can tell wou what sencer went bad and where it is located

Dec 05, 2008 | 1996 Nissan Sentra

2 Answers

Finding the Automatic and Power steering fill points.


yes fill it at the transmission dipstick good luck

Nov 23, 2008 | 1991 Nissan Sentra 2 Door

Not finding what you are looking for?
Cars & Trucks Logo

2,360 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

60667 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

705 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21936 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...