Question about 2000 Jeep Grand Cherokee

1 Answer

Starting and stay running

The Jeep will start when everything has had time to cool down, but once I start the engine and let it run for a few minutes it will not restart. I have replace the fuel pump, and fuel filter. The engine cranks but is not starting.

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

    Sergeant:

    An expert that has over 500 points.

  • Expert
  • 475 Answers

Try replacing the crack sensor on the bell housing

Posted on Oct 03, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Engine will not stay running once you turn vehicle off and try starting again


have the OBD codes read as could be a few things and the codes will point to the switch/sensor at issue

Jun 01, 2015 | 2003 Mazda Tribute

2 Answers

Why does 2000 s40 volvo turbo runs hot and the fan stays on after shut off


fans are designed to run on after you shut engine down as engine temperature rise after switching off . running hot could be caused by the top hose having gone soft when you rev the engine the water pump sucks the hose flat stopping the coolant flow or the radiator is blocked and need flushing out

Sep 16, 2014 | 2000 Volvo S40

1 Answer

Have 2004 Jeep Grand Cherokee straight 6 starts and runs fine for about 10 minutes then starts getting hot ,smoke starts coming up where the intake exhaust to engine , when you acellerate the valves r


check the coolant level. check thermostat for correct operation. Have a compression test done to check for head gasket or cracks . All indications are that the motor is overheating badly.

Mar 21, 2014 | 2004 Jeep Grand Cherokee

1 Answer

95 VAN SPORT STARTS FINE UNTIL MOTOR STARTS TO MISS THEN LOOSES SPARK


I Think Your Problem Is Still With The Fuel Supply,Have You Changed all Fuel Filters,Follow All The Fuel Lines Make Sure There Are No Kinked Fuel Hoses,Some Times You Find Small Filters In The Top Of The Fuel Injectors.
Hope This Helps

Apr 06, 2013 | 1995 Pontiac Trans Sport

1 Answer

When I am at a stop light or idle elsewhere, my jeep will start to run "rough" and then immediately the temperature gauge rises. A few times it cools itself down within a few minutes, but it has...


Coolant level first, if it is good, start it up and watch the temp gauge, you need to see if the fan is coming on when it should. Look for leaks once the temp rises and pressure is built up. Check the hoses, coolant reservoir, radiator (the top is plastic and could leak at a seam as mine did) Another possibility is the fan clutch, check to see if the fan comes on once it gets warmed up.
Hope this helps. Cheers!

Jul 20, 2011 | 2003 Jeep Liberty

2 Answers

Bailey19@i hav a 1991 h-accord ex. I have two fans. once i turn the engine off. one of the fans starts running until i disconnect the battery cable.


It actually supposed to work like this. It should turn off in a couple of minutes. Give it a try. Wait for like 10 min to see if it will stop.

Mar 16, 2011 | Honda Accord Cars & Trucks

1 Answer

How to air my radiator to a Jeep Grand Cherokee 2001 3.1 engine ?


Try removing the radiator cap when the engine is cool and top off the coolant level. Start the engine with the cap of and let it run to operating temperature which is when the thermostat opens. If you lightly grab the upper radiator hose. If it is cool or warm, the thermostat has not opened. If it is hot, the thermostat has opened. At that time have someone assist you by sitting in the car to rev the engine up (1800 to 2000rpm) and hold it there while you once again top off the radiator and tighten the cap. DO NOT BRING THE RPM DOWN TO IDLE WITHOUT HAVING THE CAP ON TIGHT! THE HOT COOLANT WILL OVERFLOW FROM THE RADIATOR! Then let the engine run to see if the air has escaped. You may have to do this procedure more than once. If at any time you feel that the engine is getting too hot, tighten the radiator cap and then shut the engine off. Then let it sit and repeat the steps above. Constantly monitor your temperature gauge at all times.

May 21, 2010 | 2000 Jeep Grand Cherokee

1 Answer

Rough running engine at temp


0340 is camshaft position sensor and the other 0325 is the knock sensor. Chances are you need to replace the sensors and good to go.

May 05, 2009 | Nissan Xterra Cars & Trucks

2 Answers

1999 4.0L Jeep Grand Cherokee shuts down after 20-30 minutes.


I'd suggest the ignition control module, however I'd have a certified mechanic check it out just in case...

Feb 01, 2009 | 1991 Jeep Cherokee Briarwood

3 Answers

My car starts and then dies


sounds like a security issue they installed a factory security system which will prevent the vehicle from running unless its reset go to passenger door lock turn key twice it worked for me after chasing other problems for a few hours

Dec 03, 2008 | 1995 Jeep Grand Cherokee

Not finding what you are looking for?
2000 Jeep Grand Cherokee Logo

127 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

60769 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...