Question about 1992 Mercedes-Benz Mercedes Benz 300 Class

1 Answer

Door Lock I have a 1991 Mercedez-Benz 190e I just received as a gift. When I go to unlock or lock the doors my key will get stuck in the key hole. I wiggle the key around but cant get my key out of the hole for some time. Thanks for the help! Jenn

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 2 Answers

Spray the key hole w/a small amount of WD-40 or Graphite Grease. Roy

Posted on Oct 10, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Key issue/ mechanical doesn't fit hole


Your car may have had a new ignition switch installed - hence the different key. The FOB may not be programmed properly to lock / unlock. Have you contacted a MB dealer?

Jun 11, 2015 | Mercedes-Benz E320 Cars & Trucks

1 Answer

Does anyone have a solution to fix my driver door locking mechanism? When I press the key fob to unlock the car doors. All the car doors unlock except for the driver door. However if you open the driver...


General advise:The lock is not ok.The same wires that lock the doors,unlock it.Before removing the lock:ceck fuses,door wiring link (near the door hinges)U may have to figure out the link covered in removabile rubber(it has a lock pin and must pull down in some cars rotate)U can clean it by air gun and contact cleaner.Rare:The door unlock pin (small plastic knob that u unlock manually from inside)has the rod dirty/stucked/twisted,ceck it to move loose.Also spray chain lube and wd40 anywhere in the lock u gain acces (the key hole,from sides,from the pin lock).U can see if it is stucked if the unlock knob has the intention to rise (small moves) but does not pop.Cheers.

Oct 24, 2013 | 2005 Renault Clio 1.5

1 Answer

How do i remove the interior door panel on 84 190e


Remove screw off striker plate at door latch and pull plastic off. Unscrew lock knob. Pull off plastic around door handles. Remove bolt from top of handle. Pull off side mirror cover. Lift and wiggle the panel up and off watching that the hole around handle doesnt get caught.

Apr 16, 2010 | 1984 Mercedes-Benz 190

1 Answer

1991 volvo 940 Driver side door not locking


your door lock cable is of the lock so it wont lock it,you will have to take of the door panel and the lock where you use to open by hand from inside the cable goes down to the lock ,connect it theres a little hole for it has to go in there make sure your clips are good on that cable put in and will lock and unlock witout problems.please leave comment,vote,note.thankyou

Sep 13, 2009 | 1991 Volvo 940

1 Answer

I have a 1995 sl320 i can't get the gas door open. and when i unlock the car remotely the light flashes but the doors don't lock or unlock remotely.


Inside the trunk there is a emergency fuel door release you can pull that will open the door. After you get it open look at the post that the locking pin goes through when the door is closed. Shoot some lubricant spray in to the hole the pin come out from and that should loosen up the pin to slide smoothly.They get stuck with age.

Sep 05, 2009 | 1995 Mercedes-Benz SL-Class

1 Answer

190d merc fob does not work operating with key disconnected battery alarm came on with hasards how do i fix


If you need to shut off the alarm without the fob insert your key in the drivers door lock and lock and unlock the car My 89 300TE does this on occasion this wil reset the alarm to off to rearm the alarm lock the car again

Jul 07, 2009 | 1991 Mercedes-Benz 190

1 Answer

98 camry door lock will not turn....


really sounds like the tumbler pins are stuck in the cylinder of the lock. mite want to spray some lubricant like(PB Blaster)or WD-40 in the cylinder key hole and push key in and out to see if tumblers will release..gd luck..chris

May 12, 2009 | 1998 Toyota Camry

1 Answer

1991 Toyota Camry DX - Front Passenger Door Lock won't disengage


Your power door locke solenoid is seized. You will need to replace it. You are going to have to get the entire door panel off, and then reach in to manually pull the solenoid arm to retract the lock mechanism. Then the door will open.

Mar 06, 2009 | 1991 Toyota Camry

1 Answer

Alarm keeps going off


you need to insert the key into the drivers door lock it then unlock it

if that don't work, do the same with the passanger door
\
which means the switch to the drivers door is bad

Jan 27, 2009 | 1991 Mercedes-Benz 190

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

297 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mercedes-Benz Experts

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

yadayada
yadayada

Level 3 Expert

61249 Answers

Michael Contreras
Michael Contreras

Level 2 Expert

164 Answers

Are you a Mercedes-Benz Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...