Question about 2006 Chrysler 300

3 Answers

RESETTING CHECK ENGINE LIGHT - 2006 Chrysler 300

Posted by on

  • blackbird28 Feb 16, 2009

    i have the same problem my check engine light came on and i just got a tune up

×

3 Answers

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 29 Answers

I can only assume you have had the code extracted and fixed the problem and looking to do a reset only. If you have not fixed the problem the reset wont do any good. That being said, in most all chrysler vehicles, the check engine light can be reset by disconnecting the negative battery cable for at least 15 seconds. However on OBD II (usually 97 and newer) models the light can only be reset with the use of a scan tool. CAUTION : If the stereo in your vehicle is equipped with an anti-theft system, make sure you have the correct activation code before disconnecting the battery cable.

Posted on Sep 26, 2008

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

I have a chrysler 300 that starts rough and the little engine light is on.

Posted on Dec 08, 2008

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Autozone will do it for free

Posted on Jan 28, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Changed battery in my 2011kia forte ex, now the check engine light won't go of. What should I do?


you may need to take it to a kia dealers workshop to get it turned off even though it is nothing serious probably. I advise you go through page at link below


Resetting the Engine Management Light Kia Forum


http://www.kia-forums.com/1g-2001-2005-rio/58062-resetting-engine-management-light.html

Jul 18, 2015 | Cars & Trucks

1 Answer

How to clear check engine light


engine lights normally have to be cleared by resetting the CPU. use a scanner for this purpose.

Apr 02, 2014 | 2000 Mercedes-Benz C-Class

1 Answer

Reset check engine light 2006 explorer


Once the problem that caused the engine light to come on is repaired the light will go off. Resetting it without a repair will not keep it off.

Feb 21, 2014 | Cars & Trucks

1 Answer

How to reset engine light chevrolet traverse 2011


The check engine light arises when ECU finds any fault in the vehicle. Check for error code using On- Board Diagnostic system and then repair the codes.

Have a professional reset by on board diagnostic: You can tell any professional mechanic who have on board diagnostic system to reset the check engine light. The mechanic would not charge you with any penny.

If you do not want to try any of the above method then try hard resetting the check engine light; for hard resetting, follow the steps below:

1. Remove the battery terminals

2. Switch on the lights and press the horn for few minutes until last bit of electricity is drained.

3. When the horn stops working, you can now connect the battery again.

Jun 26, 2013 | Cars & Trucks

1 Answer

Resetting the check engine light


You need a OBD2-device for that.

Aug 18, 2012 | 2006 Lotus Elise

3 Answers

My Geo still doesn't start after resetting check engine light switch!


The check engine light being on indicates a problem in the electronic system that controls the engine, so resetting the CE light without reading the code that was set with the light being turned on by the on board computer has not fixed the problem that is keeping it from starting. This is an early system called OBD1, it requires a special scanner to plug in and read the fault codes you have. .

Feb 19, 2012 | Cars & Trucks

1 Answer

Check engine light stays on


Go to Autozone and have them scan it for free. They'll give you a slip that has the code and possible issues with the car. Many times it'll be an oxygen sensor or catalytic converter. You can try resetting the code and see if it comes back. They can do that through the scanner at Autozone. It's a nice service they provide. Also, check to see if your engine needs to be tuned up. My 2000 Honda Odyssey had a check engine light around 105k and I had the parts to tune up (plugs). After replacing the plugs and resetting the check engine light the check engine light never came back.

Dec 06, 2011 | 2004 Honda CR-V

1 Answer

Resetting the check engine light?


two ways,,disconnect the battery for 15 minuets,,then u will have to reprogram the radio,,or,,go back to advance & have them clear it with the scanner,,it can clear codes,,hope it helped

Apr 05, 2010 | 2002 Pontiac Bonneville

2 Answers

Why does my check engine light keep coming on


either a problem with engine our if no problem then it needs resetting by diagnose tool

Sep 30, 2009 | 2004 Toyota Corolla

Not finding what you are looking for?
2006 Chrysler 300 Logo

3,811 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

61249 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

chargerhp
chargerhp

Level 3 Expert

813 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...