SOURCE: 1998 GMC Sierra- runs rough then stalls when
had this problem on my neighbors 98 chevy truck with the same engine !!
it turnd out too be the fuel pressure regulator,you have too pull the upper intake too replace it!!
SOURCE: 94 GMC truck diesel starts,runs and then dies and will not start
I have the same problem and have trouble codes 35 and 36. I found out that there is a computer module that needs replaced as it sits low in a valley and gets hot and seperates. I am reseaching about the a/m fix that installs the new module away from heat.
SOURCE: Truck won't start right away when its hot.
U MAY HAVE A DEFECTIVE ENGINE COOLANT TEMP (ECT) SENSOR, U NEED A SCAN TOOL TO TEST THIS PART, THIS IS NOT THE SENDER FOR THE TEMP GUAGE THIS IS THE SENSOR THAT TELLS THE FUEL INJECTION COMPUTER HOW COLD OR HOT THE ENGINE IS, IF IT READS LOW THE SYSTEM WILL GET TO MUCH FUEL AND CAUSE A HARD START, DO U NOTICE ANY BLACK SMOKE WHEN IT FINALLY STARTS?
SOURCE: 1987 GMC sierra , no fuel pump power.
The inline fuel pump fuse on the passenger side firewall is good? Are you jumping it with 12 volts at the test lead or the fuse?
SOURCE: fuel pump fuse located on 1997 gmc sierra
The fuse is actually a Relay Switch and its located in the Fuse Relay Center on the driverside of the engine compartment. The Black Box is labled Fuse Relay Center, the diagram on the cap displays which Relay is the Fuel Pump relay...the Relay switch is usually $8-$15 depending on where you shop
1,325 views
Usually answered in minutes!
×