Question about 1992 Dodge Dakota

1 Answer

1992 Dodge Dakota v8 5.2

My truck back fires changed all plugs and sensors. took it to mechanic no scanned problems. also when i wigle the ignition switch it revs up fine the do it again it dose not rev past 2000 like like it is choking then dies.

Posted by on

  • yadayada
    yadayada May 11, 2010

    Because the scan shows no problem that does not mean there is no problem, how about an intake manifold leak?

×

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 4 Answers

Check your exaust doughnuts and then check your fuel pump

Posted on Jan 20, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

92 Dakota, 3.9, automatic. Engine backfired, coughed, and died while driving. Acted as if it ran out of gas. Would not restart. Replaced fuel filter and electric fuel pump, still no start. Any ideas?


Make sure you have spark. Crank sensor is located at the back passenger side of the engine just infront of the the transmission bell housing, coil is on the side of the engine right next to the distributor, and also make sure that you do not have a broken ECU. I had one once that I fought an intermittent problem with dying for no apparent reason. Truck would usually fire right back up, but would die at unrelated intervals. Ended up being the center plug on the ECU. Took two replacement ECUs to get one that was good as the first replacement had the same issue of being broken on the center plug in.

Jan 11, 2017 | 1992 Dodge Dakota

1 Answer

1992 dodge dakota no spark


Did you do a fault code test to see if anything shows up that might explain the no spark? The ignition control module is part of the ECM in this truck you might have a defective circuit.

Oct 10, 2016 | 1992 Dodge Dakota

1 Answer

Will fire ,but will not turn over


Dodge Dakota Crank No Start Fix - YouTube

? 8:10
https://www.youtube.com/watch?v=a-rfAd0YLg0
Jun 29, 2014 - Uploaded by AJ Pierce
In this video, I will show you how I fixed my 1992 Dodge Dakotanot starting. ... Engine cranks but won't start - Duration: 18:30. jimthecarguy ...

Inspect Fuses if Engine Cranks But Does Not Start : Dodge ...

repairpal.com > Problems > Dodge > Dakota
Engine Will Not Start Due to Blown Door Lock Fuse on Dodge Dakota ... cap and rotor, wires, plugs, coil, fuel pump assy, coil pickup sensor, crank position sensor and have new ECM on the way, Cranks but won't fire. ... 1990 Dodge Dakota.

Dakota won't Start - Discussion on Topix

www.topix.com > Dodge Dakota
Jan 22, 2009 - have a 1993 dodge dakota sport that wont start. when you turn the key on there is no power to the fuel pump and does not fire. any ideas ... I just bought a1990 Dodge Dakota Sport 4x4 5-Speed, there is only one problem, it only .... I went to move it the other day, it would turn over, but had no spark or gas.

Dodge Dakota Questions - PROBLEM STARTING - CarGurus

www.cargurus.com > Questions > Dodge > Dakota

CarGurus

Jan 09, 2016 | 1990 Dodge Dakota

1 Answer

How to wire ignition system of 1992 dodge dakota


Make sure distributer is at Cylinder 1 at TDC (top dead center).

May 16, 2014 | 1992 Dodge Dakota

1 Answer

On my 92 dakota with 3.9..cahanged ecu, coil pick up. crank snsr, cap, rotor, coil, ckd under fuse box, no corrotion ..just turns over, no fire


check that the cam shaft is turning . Back firing is a timing issue as it indicates ignition too early (inlet valve still open ) or valve timing out ( inlet valve opening too soon). Check that the immobiliser is operational.

Jan 09, 2014 | 1992 Dodge Dakota

1 Answer

Misfiring 1,3,5, dodge dakota 1998


What about checking for vacuum leaks or low compression or a leaking head gaskt

Jul 09, 2013 | Cars & Trucks

1 Answer

Would the ignition switch cause 92 dodge dakota not to fire an no gas


It is possible and the check is to get a test light and check for power at the coils and fuel pump. Have the ignition on and in the engine run position for this test. Remember the fault could be in either a fusible link or in a crank position sensor .

Feb 17, 2013 | 1992 Dodge Dakota

1 Answer

1998 dodge dakota 3.9L engine flooding problem


What are the symptoms? Why do you think it's flooding?

Jan 28, 2013 | 1998 Dodge Dakota

1 Answer

1992 dodge dakota v8 5.2l sputters and back fires at a steady


a common problem with these engines is a leaky intake gasket which sucks in outside air spray carb cleaner around intake base see if engine idle increases .most likely this is your problem

Feb 26, 2009 | 1992 Dodge Dakota

1 Answer

1992 dodge dakota starting problem


The first thing you need is to have the unit scanned. Check things like the baro sensor,map sensor,coolant temp. and the TP sensor.Also check your fuel pressure,volume and injector spray pattern. I think you will have found your problem,but if not hit me back with engine size and any codes,Good Luck.

Aug 13, 2008 | 1992 Dodge Dakota

Not finding what you are looking for?
1992 Dodge Dakota Logo

170 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

70387 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22041 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6879 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...