Question about Volkswagen Jetta

1 Answer

Remove a 93 Golf 3 VR6 Dashboard

I have a question that I've searched all over the internet for and found no straight answer. The question is how do I remove the dashboard from my 93 golf VR6. I had tried but I can not find what is holding this thing to the car. You help would be greatly appreciated.

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Genius:

    An expert who has answered 1,000 questions.

  • Master
  • 2,035 Answers

  1. Remove a 93 Golf 3 VR6 Dashboard - 5b63f60.jpge173e8a.jpg
  2. On Cabriolet with an air bag, disconnect the negative battery cable and wait at least 20 minutes for the back-up power supply to discharge. Make sure no one is in the vehicle when connecting the battery. Unintended deployment of the air bag can cause serious or fatal injury.
  3. Disconnect the negative battery cable.
  4. Remove the gear shift knob and boot and remove the center console.
  5. Remove the steering wheel.
  6. Remove the knee bar from below the dashboard.
  7. Remove the steering column support bracket and lower the column.
  8. Pull the knobs off the heater controls and remove the control assembly and the radio.
  9. Remove the headlight switch and switch blanks to gain access to the screws. Remove the instrument cluster and trim panel around the cluster.
  10. Remove the glove compartment.
  11. At the firewall, remove the plastic tray and remove the 2 nuts holding the top of the dashboard.
  12. .Remove the main fuse panel and disconnect the plugs at the back. Disconnect the ground wires.
  13. Disconnect any remaining wiring from the dashboard and remove the 4 last screws; 1 at each end and 1 at each end of the instrument cluster area. Remove the dashboard.
To install:
  1. Fit the dashboard into place and start all 4 screws, then tighten them.
  2. Install the fuse panel and connect the wiring.
  3. Secure the steering column into place.
  4. Install the switches and instrument cluster.
  5. Install the heater controls and radio.
  6. Install the console and connect all wiring.
  7. Connect the battery to test the electrical system.
  8. Install the steering wheel, knee bar and all remaining components.
Good luck...

Posted on Sep 26, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1996 golf vr6 airbag light on


I think you will find the Airbag is defective. Make sure you disarm this system before you touch anything, it can kill you.

May 25, 2012 | 1996 Volkswagen Golf

2 Answers

Fuse + relay numbers and positions for mk3 golf vr6


give me a email and exactly what diagram you need and i will send it to you in a word document

Apr 23, 2011 | 1995 Volkswagen Golf

1 Answer

I have a 2000 Golf GTI VR6 and I am trying to find the fuse for the oxygen sensor, I was told the fault, Found code for O2 sensor heater Bank 1 sensor 1 open circuit. Front O2 sensor failed. Might be the...


if you dont get the o2 sensors replaced it will cause the car to overheat cause im having the same problem with my golf gti vr6 had it dionosed and both my o2 sensors are out nothing else is bad and now it overheats due to the o2 sensors

Aug 28, 2010 | Volkswagen GTI Cars & Trucks

1 Answer

93 Golf VR6, headlight high and low beams are very


Did you check battery charge.Must be 13.8 v-14.4v.Or your battery is gone.

May 12, 2010 | Cars & Trucks

1 Answer

How to fit a fuel pump to a golf vr6 1994


The pump is in the fuel tank. It can be accessed under the right side of the rear seat. 6f73d2f.jpg


Disconnect the lines and wiring harness and turn the big black 7398ffe.jpgplastic locking nut counter clockwise till its loose. Pull the pump unit out straight up and reverse procedure to reinstall.

Feb 28, 2010 | 1994 Volkswagen Golf

1 Answer

Will only select 3rd & 4th


sounds like you droped the jack shaft in the tranny

AAMCO free quotes and every thing


salvage yards warenty tranys for up to 6 monthes

Jan 10, 2010 | 1995 Volkswagen Golf

1 Answer

Is there a Haynes Manual for the 1.0L Seat Ibiza, 2000 version?


There is a haynes manual for 2000 on. All Fiat/ Seal have minor differences. I think that yours is probably the one that you have to remove the hub nut to take off the hub.

Jun 09, 2009 | 2000 Volkswagen Golf

1 Answer

Seizing brake calliper on Vw Corrado VR6 Storm 1995.


i recomend to go to your local auto parts store and buy rebuild calipers . not much more money than the rebuild kits and they have a warranty.

Jan 29, 2009 | 1994 Volkswagen Corrado

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

4,379 people viewed this question

Ask a Question

Usually answered in minutes!

Top Volkswagen Experts

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

yadayada
yadayada

Level 3 Expert

60769 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you a Volkswagen Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...