Question about 1999 Dodge Intrepid

1 Answer

Adjusting the headlights on a 99 dodge intrepid

I had to replace the headlights in my car and i need to know how to adjust them

Posted by on

  • Anonymous Mar 28, 2014

    I replaced my headlight with new Headlight assembly, direct replacement, but adjusting them so they shin straight ahead is giving me trouble. The Adjusting screw on the back will only Adjust a little, The lights shin to far to the right

×

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Expert
  • 36 Answers

On the back of the headlight their is a bolt which you could turn it one way and it lowers the headlight the other way it picks it up.

Posted on Nov 03, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to adjust a shifting cable for 2000 dodge intrepid


there should be adjustment on one end or the other and if not the cable will need to be replaced Jim H

Jun 07, 2015 | 2000 Dodge Intrepid

1 Answer

How to adjust headlights


I installed eagle eyes aftermarket headlights on my 99 Chevy Tahoe I need to know how to adjust them. I know there is 2 adjustment nuts on top is that what I use to adjust them?

Jan 12, 2014 | 2004 Toyota Highlander

1 Answer

How do I find the headlight adjustment


You need an aiming tool to use those "two little" adjusters.

Dec 15, 2013 | 2003 Dodge Intrepid

1 Answer

I have a 99 dodge intrepid and when the engine gets warm it starts to have a deep ticking noise


This could be valve tappets tapping inside of the engine indicating hydraulic lifters , if so equipped, not adjusting well to the heat.

Nov 12, 2010 | 1999 Dodge Intrepid

1 Answer

Where are adjustment screws on my 2002 dodge intrepid headlight?


On top of the housing of the headlight, you will see some small holes. With the use of a flashlight, look through these holes and you will see some torqux screws (T-20 or T-25 star bit). First loosen the headlight housing. With the use of the stars bits, adjust the headlight as needed and then re-tigthen the housing. You're done.

Oct 06, 2010 | 1999 Dodge Intrepid

1 Answer

Can not find headlight adjustment screws


YOU NEED A HAYNES REPAIR MANUAL.IT HAS 3 HEAD LIGHT ADJUSTMENT SCREWS WITH PHOTOS.IT WOULD BETTER TO TAKE TO A GARAGE.SHOULDNT COST MUCH BUT GET A PRICE CHECK.THEY HAVE EQUIPMENT TO ADJUST HEAD LIGHTS.IF YOU TRY ADJUSTING THEM YOUR SELF.YOUR HEAD LIGHTS WILL BLIND OTHER DRIVERS IF ADJUSTMENT NOT CORRECT.

Mar 06, 2010 | 1999 Dodge Intrepid

1 Answer

99 Grand Voyager, headlamps adjusted too low. Do I need a special tool to adjust the height? Do you just turn the adjustment screw or is there some release set screw that you have to loosen before you can...


Purchased a 4 mm socket and had the necessary adjustment with the adjustment screw right above the headlights. Clockwise will raise the lights while counterclockwise will lower the lights.

Feb 07, 2010 | 1999 Dodge Grand Caravan

1 Answer

Where is the vertical adjusting screw for the headlight aiming located?


open the hood, right above the lamp are the adjusting screws, with a built in level on most cars now days

Oct 13, 2009 | 2001 Dodge Intrepid

1 Answer

How to remove rear abs sensor from rotor a 99 dodge intrepid


Raise and support the vehicle. Remove the rear wheel hub and bearing with a socket wrench. Back the parking brake shoes away from the rotor using the adjuster star wheel. Remove the parking brake shoe adjuster spring and the shoe adjuster with a socket wrenchDisconnect the hold-down clip and pin for the upper brake shoe so you can remove the upper shoe from the actuator lever with a socket wrenchRemove the return spring from the lower brake shoe and disconnect the shoe actuator lever from the end of the parking brake cable. Detach the hold-down clip and pin from the lower brake shoe and remove the lower brake shoe with a socket wrench.

Oct 09, 2009 | 1999 Dodge Intrepid

1 Answer

Headlight


most light systems have adjustment screws that hold the light systems in place. look around the edge of the head lights. they may be really difficult to get to though....

Jan 02, 2009 | 1999 Dodge Intrepid

Not finding what you are looking for?
1999 Dodge Intrepid Logo

Related Topics:

458 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

60769 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...