Question about 2002 Jeep Grand Cherokee

1 Answer

02 Jeep Grand Cherokee Low HL & BL Out?

I have a 2002 Jeep Grand Cherokee with a considerable amount of miles on it. Recently I discovered that both my driver's side low beam head light and brake light are out. I went to change the low beam head light and found nothing wrong with the current bulb. I still replaced it with a brand new bulb and the light still does not work. I didn't notice any corrosion. When I checked my fuses I discovered that there is a 5 amp blue fuse in the 14 spot (low high beams.) According to the manual, this should be a 10 amp red fuse? I have been driving the car for at least 3 years and never touched the fuses. As a separate question, I purchased 10 amp red fuses to put in the 14 slot, but they are actually larger than my fuses. I was under the impression that fuses were fairly universal. Any information would be greatly appreciated! Thanks!

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Well if all those years your car was working perfectly fine with that blue fuse just get a new 1 and replace it. But then if the lights still don't work check all the wiring in the car that goes to the lights and if there is no problem go to a mechanic and ask him to look at it. That's all i can really help you with i'm sorry i'm not a mechanic yet or i would help you further.

Posted on Oct 11, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Need diagram for fuse panel on 2002 Jeep Grand Cherokee


Hi George:
Other Jeep lover here (Grand Cherokee Limited 5.2L V8)... keep in mind that all this information is in the WJ owners manual...

11_21_2011_8_31_50_pm.jpg

Image: WJ Junction Block (under dash, left of steering wheel)


11_21_2011_8_32_28_pm.jpg

Image: Grand Cherokee fuses 1999-2004


11_21_2011_8_33_59_pm.jpg

Image: PDC (Power Distribution Center, under hood)

Feel free to contact us in the previous link if need additional details about this information.

Hope this helps; also keep in mind that your feedback is important and I'll appreciate your time and consideration if you leave some testimonial comment about this answer.

Thank you for using Fixya, and have a nice day.

Oct 31, 2011 | 2002 Jeep Grand Cherokee

1 Answer

What belt do I purchase for a 2002 jeep grand Cherokee 6 cylinder


this vehicle should have only one drive belt just ask at any reputable autoparts store for a serpentine drive belt for a 02 jeep grand cherokee with a i assume a 4.0

Sep 21, 2010 | 2002 Jeep Grand Cherokee

2 Answers

Oil preser lowers at lights


Hi there,

That is natural. The oil pressure rises in response to engine rpm's.

Idling at a light? Low oil pressure

55 mph on the highway? Higher oil pressure

Good job keeping an eye on it. And remember to change your oil every 3,000 miles.

Best regards
Mike a6b05ec.gif

Aug 14, 2010 | 2002 Jeep Grand Cherokee

1 Answer

Airbag and seatbelt light stay on in 2002 Jeep Grand Cherokee. The lights randomly came on for no reason.


Just recently, I inadvertently removed the yellow doohickey that holds the 2 x 10 amp fuses in the interior fuse bank of my 2002 WJ Jeep Grand Cherokee Laredo. I checked the fuses and they were ok so I inserted the fuse holder back in.. Low and behold the seatbelt and airbag light came on and stayed on. After several quick fixes etc to get the lights to go out, I finally returned to the fuse holder and discovered that A. You need to squeeze in the tabs to get the fuse holder out and B. the fuse holder when being re-inserted will not automatically clip in... you have to squeeze the tabs again to press the fuse holder fully home. I started the old girl up again and no more lights.

Jul 20, 2010 | 2004 Jeep Grand Cherokee

1 Answer

Location of tps and map sensor on a 02 jeep grand cherokee 4.7l


Both are attached to the throttle body. Tps is on the other end of the throttle plate shaft opposite the linkage, MAP is on the side...has small vacuum hose underneath and is flat, about 3" long. The other item on the TB is the idle air motor, next to tps.

May 07, 2010 | 2002 Jeep Grand Cherokee

4 Answers

2001 Jeep Grand Cherokee, steering noise, restricted lock


There's a technical bulletin on that from Chrysler....The power steering lines need to be replaced. I have the same problem as you see this link - http://www.wjjeeps.com/tsb.htm#STEERING

SUBJECT:
Steering Honk On 4.0L And 4.7L LHD Grand Cherokee Vehicles
OVERVIEW:
This bulletin involves the replacement of the power steering pressure
and return hoses and tube.
MODELS:
1999 - 2002 (WJ) Grand Cherokee (Domestic and International Markets)
2001 - 2002 (WG) Grand Cherokee (International Markets)
NOTE: THIS BULLETIN APPLIES TO 1999 - 2000 4.7L AND 1999 - 2002 4.0L
GRAND CHEROKEE VEHICLES THAT ARE LEFT HAND DRIVE (LHD) AND
ARE NOT EQUIPPED WITH HYDRAULIC COOLING.
SYMPTOM/CONDITION:
Some vehicles may exhibit a honk-like sound from the power steering
system. This sound occurs most often during a low speed right hand turn,
as would occur during parking lot maneuvers.
DIAGNOSIS:
If the customer indicates that the above condition is present, perform the section of
the Repair Procedure that is appropriate for the equipped engine.
PARTS REQUIRED:
Qty. Part No. Description
1 04883077 Fluid, Power Steering (MS-5931 quart)
1 05080950AA Hose, Pressure (4.7L)
1 52088116AB Fitting, Pressure Hose - Quick Connect At Pump (4.7L)
19-005-02 -2-
Qty. Part No. Description
1 05080951AA Hose, Return (4.7L)
2 **06504502** Clamp, Hose (4.0L or 4.7L)
1 **52088452AE** Hose, Pressure (4.0L)
1 **52088774AC** Hose, Return (4.0L)
1 **52088775AB** Tube, Return (4.0L)
6 **34201631** Rivet, Plastic Black (Front Fascia - 4.0L)
1 **06102141AA** Screw, Pressure Hose (6 mm - 4.0L)
REPAIR PROCEDURE:
**IF VEHICLE IS EQUIPPED WITH A 4.0L ENGINE:**
1. Remove the front fascia panel.
Fig.

Aug 24, 2009 | 2001 Jeep Grand Cherokee

1 Answer

2002 Jeep Grand Cherokee Limited Not Starting Intermittently


Check the battery. If it starts to fail it will start doing any conceivable thing including failing to start the car. Have the battery checked with a load tester. A simple voltmeter will not give an account of the requirements needed and the ability of the battery to meet those requirements.

Jul 01, 2009 | 2002 Jeep Grand Cherokee

1 Answer

2002 Jeep Grand cherokee


you really need to get to a dealership and check for trouble codes and go from there

Jun 24, 2009 | 2006 Jeep Grand Cherokee

2 Answers

2002 Jeep Grand Cherokee Lardo misfiring


You say you changed the cam sensor. A1391 code is a crank sensor on the top of the trans. bell housing.

Feb 22, 2009 | 2002 Jeep Grand Cherokee

1 Answer

2002 Jeep Grand Cherokee Limited pre form service needs to be erased


Service Interval

When this feature is selected a service interval between 2,000 miles (3,200 km) and 6,000 miles (10 000 km) in 500 mile (800 km) increments may be selected. Pressing the STEP button when in this display will select distances between 2,000 miles (3,200 km) and 6,000 miles (10,000 km) in 500 mile (800 km) increments.

Reset Service Distance (Displays Only if Service Interval was Changed)

When this feature is selected the current accumulated service distance can be reset to the newly selected service interval. Pressing the STEP button when in this display will select "Yes" or "No."

Nov 02, 2008 | 2006 Jeep Grand Cherokee

Not finding what you are looking for?
2002 Jeep Grand Cherokee Logo

183 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

60769 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...