Question about 2000 Cadillac Seville

Open Question

98 cadillac seville sls

Blows hot air
Service Stability Sys message
ABS/Traction Control lights stay on

Codes that come up --- All are current, not history

ABS C1255
IPM B1344
RSS C1738

Posted by on

3 Suggested Answers

  • 1 Answer

SOURCE: abs light/traction control light

You can check out what the trouble code is by pushing and holding the information button and the up arrow (right side of instrument cluster above the radio) until all the instrument clusters light. Press the information button (last) to enter test mode. I've had an error C1234, meaning Left rear wheel sensor fault. I found the problem to be a corroded connector under the chasis just under the rear left door about 2 feet in. I had to by-pass (replace 1 wire due to corrosion at the connector.

Posted on Sep 15, 2009

  • 173 Answers

SOURCE: 1996 Cadillac SLS ABS and Traction lights

check the abs connections at every wheel .

Posted on Apr 03, 2010

  • 5370 Answers

SOURCE: My Cadillac Deville dhs 2001 have

The stability and ABS systems will definitely be affected by wheel speed sensor.Get the wheel sensors checked. ---------- But as you mentioned this light comes ON, that means there is a error code saved in the system.First of all, you need to retrieve the error codes.Once you retrieve the codes, then only as per codes, it will point out, what the actual, fault is.In some cases its ABS module, that is faulty.In some cases its speed sensor faulty, in some cases its ignition switch issue.But directly going and replacing parts,is not advisable.First retrieve codes.Then get the following parts checked as per the codes.-------- For exact procedure to retrieve codes, please click the link below and read the instructions:---- http://technoanswers.blogspot.com/2011/06/abstraction-and-service-stability-light.html ------------ This should help.Thanks.Helpmech.

Posted on Jun 14, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I was driving and all of a sudden all of this pops up I drive a 2006 suburban. Can someone help me figure out what this all means?


Search Results

    'Service Stability' Message flashing on dash. What does this ...

    repairpal.com > ... > Suburban 1500 > 2006 Chevrolet Suburban 1500
    Jun 7, 2012 - What does this mean? never seen b4 on 2006 Chevrolet Suburban 1500... 2006 Chevrolet Suburban 1500; >; 'Service Stability' Message ...

    Service Stability System Warning - Help! - Chevrolet Forum - Chevy ...

    chevroletforum.com > ... > Tahoe & Suburban
    Sep 1, 2012 - Tahoe & Suburban The power, space, and brutal towing ability make the Tahoe and its longer sibling, ... the ABS light, and the Stability Control light are all on and the DIC says Service Stability System. ... Join Date: Apr 2006. Service Stability, ABS and Traction Lights On - Chevrolet Forum ...
    Feb 20, 2014
    HELP - Service Stabilitrak & Service Traction Control - Chevrolet ...
    Aug 30, 2011
    Service Traction Control - Stabilitrak and ABS light, Help ...
    Feb 12, 2011
    More results from chevroletforum.com

    Chevrolet Suburban 1500 LTZ: Yesterday I was cruising down

    www.justanswer.com > Chevy
    Yesterday I was cruising down the highway in my 2006 Suburban LTZ and I got "Service Stability" message and the Traction Control light and ABS light are lit.

Feb 08, 2016 | Cars & Trucks

2 Answers

Why does my ABS light stays on and sometimes i get a vibration in the brake petal causing my 2002 Cadillac escalade not wanting to stop?


Sounds like a fault with the Antilock Braking System. The vibration in the pedal is the ABS working. With your foot on the brake pedal, it releases and re-applies the brakes to stop a skid from the wheels locking up. You need professional service for brakes.

Seems to be a known issue on all Cadillac and requires the ABS module to be replaced.

ABS Light Due to ABS Control Module Failure : Cadillac ...

repairpal.com > Problems > Cadillac > DeVille Cadillac DeVille ABS Light Due to ABS Control Module Failure. This is a verified problem based on 126 reports. Learn more about this problem, when it occurs ...

ABS Light Due to ABS Control Module Failure : Cadillac ...

repairpal.com > Problems > Cadillac > Seville STS Traction control and ABS lights stay on dash. This is due to ecbtm Module gone bad. replace Module and this should fix the problem. You can go by the VIN and ...

ABS Light Due to ABS Control Module Failure : Cadillac ...

repairpal.com > Problems > Cadillac > DeVille DTS ABS Light Due to Control Module Failure on Cadillac DeVille DTS. The anti-lock ... ABS and Traction control light stays on. ... abs light to abs control stay on.

ABS Light Due to ABS Control Module Failure : Cadillac ...

repairpal.com > Problems > Cadillac > Seville SLS ABS Light Due to Control Module Failure on Cadillac Seville SLS. The anti-lock brake ... SLS135,000Jumsee. Abs and traction lights stay on when started.

Jan 12, 2016 | Cadillac Cars & Trucks

1 Answer

How can I tell if I have a faulty wheel speed sensor on 2002 Cadillac Seville SLS


One possible cause is that these systems remember values from the last time the vehicle was started. Sounds like sitting for a long time is caused unacceptable differences between current and last readings. This is possibly because of a vehicle attitude change, often due to a low tire pressure. Modern low profile tires are very sensitive to pressure changes - pressures tend to drastically change with changing ambient temperature and will deflate over time.
Also try starting the vehicle more frequently - that is needed to keep the drive train and electronic systems in good working order.

Sep 14, 2014 | 2002 Cadillac Seville SLS

1 Answer

Abs traction control


bad wheel speed sensor

Mar 03, 2014 | 2001 Cadillac DeVille

1 Answer

2001 cadillac deville service system stability


Whenever this warning or any other stays on in the dash it is indicating that the systems control module has detected a fault, it then disables the system as long as the light is on. You must now have the dealer hook up a special electronic diagnostic tool and "scan" the system for the fault code that is stored for the problem(s)

Sep 19, 2012 | 2000 Cadillac DeVille

1 Answer

1996 Cadillac SLS ABS and Traction lights


check the abs connections at every wheel .

Jan 04, 2010 | 1996 Cadillac Seville CA Value

1 Answer

I have a 97 STS. I just changed the rear brakes -


i have similar problem on my 97 SLS only current codes are TCS C 1235 and MSM B2120

Aug 02, 2009 | 1997 Cadillac Seville

1 Answer

94 cadillac seville sls


whats the numbers on the pcm? should start with 16 its located behind the glove box

Jul 25, 2009 | 1994 Cadillac Seville

2 Answers

Abs light/traction control light


You can check out what the trouble code is by pushing and holding the information button and the up arrow (right side of instrument cluster above the radio) until all the instrument clusters light. Press the information button (last) to enter test mode. I've had an error C1234, meaning Left rear wheel sensor fault. I found the problem to be a corroded connector under the chasis just under the rear left door about 2 feet in. I had to by-pass (replace 1 wire due to corrosion at the connector.

Mar 18, 2009 | 2001 Cadillac Seville

Not finding what you are looking for?
2000 Cadillac Seville Logo

Related Topics:

235 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cadillac Experts

yadayada
yadayada

Level 3 Expert

60960 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Cadillac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...