Question about 2000 Cadillac Catera

2 Answers

Push on brakes and doesn't light up - 2000 Cadillac Catera

Posted by on

  • gonz4989 Sep 26, 2008

    Cadilac Cattera the whole center light on the trunk does not alluminate only the end lights come on...

×

2 Answers

What switch

Posted on Oct 17, 2008

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 35 Answers

Replace switch

Posted on Sep 24, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do I fix brake light?


check the brake light switch its located at the bottom of the steering colume near the firewall. one wire will have battery voltage all the time and the other wire will only have voltage when the brake pedal is pushed. if it doesn`t then it needs replacing usually the problem, on some they get out of adjustment.

Sep 24, 2014 | Cars & Trucks

1 Answer

Brake lights


Check the bulbs first. If those are good check the brake light fuse. If that is good find the brake light switch under the drivers side of the dash. One wire should have power all the time. There should be a wire that gets power whe you push down on the pedal. If this doesn't happen replace the brake switch.

Aug 09, 2012 | 1997 Honda Passport

1 Answer

2003 chrysler concorde ,


Most vehicles have a brake sensor on the top of the brake pedal and it may be out of adjustment. It's very simple to adjust. Try checking that out. If it's out of adjustment it doesn't know you're foot is on the brake until you push the pedal very hard. But don't adjust it too far the other way or you're brake lights won't work right.

Jul 03, 2012 | 2003 Chrysler Concorde

1 Answer

Hummer H3 airbag light wont go off


Airbag light on in a Hummer H3 Dashboard???Here is the fix...
Start the engine of your car, set the parking brake, hold the regular brake pedal down with your right foot. Push down the parking brakepedal to its fully-applied position with your left foot. Now while you are still holding the regular brake pedal down. Quickly release the parking brake, Pull the bottom edge of the lever, located above the parking brake pedal, with the parking brake
symbol, directly rearward to release the parking brake. Make sure pedal snaps hard all the way back releasing the parking brake... If this doesn't work the first try, try it 3-5 times and it shall work... The airbag light will go off...


NOTE: The parking brake pedal is located to the left of the regular brake pedal, near the driver's door.
&

The parking brake lever is located above the parking brake pedal, with the parking brake symbol.

May 28, 2012 | 2006 Hummer H3

1 Answer

I have a 2006 is250 lexus push button start and it only starts sometimes....radio, lights, nav everything works but it won't crank....takes 3-4 times before it cranks and it doesn't happen eve


The first thing you want to check for is the brake signal,without this signal it will not crank,this is the easy one make sure you get brake light,the second is to have the starter tested by a direct method,this gives the indication of the health of the starter

Mar 22, 2012 | Lexus IS 250 Cars & Trucks

1 Answer

B LIGHTS NO WORK


"B" lights? You mean brake lights? Could be the brake light switch. I'd start there. It's fairly easy to replace. To check the brake switch, remove it, and see if the piece that pushes in is stuck be gently pressing on it and if it doesn't press in, gently pull on it to see if comes out. If it doesn't not freely move, that is probably your issue. The brake pedal assembly presses it in when you step on it. For a 2004 Forenza, the part # is 37740-85Z22. If you have a 2005 - 2008 Forenza, the part # is 37740-86Z21. Both are under $20.

Nov 25, 2011 | 2004 Suzuki Forenza

2 Answers

Where are the fuses located on a 1994 Honda Civic? My brake lights won't turn off.


I don't have a fuse diagram, but you may want to try pulling the connector off the stoplight switch above the brake pedal. If that doesn't turn the lights off, your relay is shorted and must be replaced. If the lights go out, check the switch to see if the button is springing out or just replace it. Cost is $20 or less at autozone.
jturcotte_642.jpg

Oct 06, 2011 | 1994 Honda Civic

1 Answer

On my 2003 model 2500HD Silverado, the right tail light doesn't illuminate, although the brake light actuates normally. I have the right blinker function and the back up light also works. I had power...


In those years of chevy trucks they have circuit board in the tail light assembly. You will need to replace the circuit board ( the thing the bulbs push into) you can perchase one at your local auto parts store.

Jul 08, 2011 | Chevrolet 2500 Cars & Trucks

1 Answer

Changed back brake pads on 2004 tahoe , now the brake light and stabilty light is staying on . why? and what do i need to do?


If you have disc brakes on back, did you open the bleeder valve to compress the caliper piston? If not and you pushed the fluid back into the system, you could have blown the seals in the antilock brake system, This doesn't happen all the time, but does happen. If you did the brakes will still work, just not the ABS.

May 22, 2011 | 2004 Chevrolet Tahoe

3 Answers

How do you put down the top on a ford 1998 mustang convertible


Make sure the parking brake is engaged first. Then just push the button next to the parjing brake.

Mar 27, 2010 | 1998 Ford Mustang

Not finding what you are looking for?
2000 Cadillac Catera Logo

Related Topics:

34 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cadillac Experts

yadayada
yadayada

Level 3 Expert

60960 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Cadillac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...