Question about 1999 Chevrolet Blazer

1 Answer

1999 Chevy Blazer Starter

How do you change the starter on a 1999 chevy blazer and where would the starter be located throughout the engine?

Posted by on

  • Anonymous Mar 13, 2014

    reset security light on 1999 Ls chevy blazer

  • Anonymous Mar 16, 2014

    starter doesn't make a sound

×

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 125 Answers

The starter is located on the passenger side lower motor. it has two bolts in it that hold it in place. it actually goes through a hole/slot in the transmission to the flex plate.

1st. disconnect the negative cable on the battery.
2nd. raise the vehicle safely and place a jack stand under the vehicle out of your way but near where you will be working(for safety).
3rd. remove the two bolts that hold the starter in place.
4th. remove the wires from the back of the starter.
5th. install in reverse order of above.

note: there may be little plates between the starter and the mounting points called shims. if there are then make sure you put them back.

Posted on Sep 24, 2008

  • joe123456588 Dec 12, 2010

    I did this job last night. It is unbelievable how tight the opening is compared to the size of the starter. I rolled it around and around for about 15 minutes, and it surprisingly did come out. It was almost equally as difficult to get the new one back in, but it does go. FYI, the wires are short, and you have to remove them before you pull the starter out, which is no easy task in itself.

×

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 96 Chevy Blazer 4 door I've change the ignition switch starter all that good old stuff if I turn the key and jumper by the starter it will run I have liked it just no crank no start


1989 Chevy blazer 4.3 won't start..I have ... - CarGurus

www.cargurus.com > Questions > Chevrolet > BlazerCarGurusJan 30, 2013 - 96 Chevy S10 Blazer with 4.3 L engine vortex will turn over but won'tstart. ... i a 93 k5 blazer 5.7tbi in cold weather it will not start, if i hook jumper ... was told it just needed a Fuel pump, I replaced the Fuel pump, and the Filter, ...

Oct 12, 2015 | Cars & Trucks

2 Answers

Where is the starter relay located on a 95 chevy blazer


Hi natgonzo, your Blazer doesn't use a starter relay, it only has a starter solenoid which is attached to the top of the starter motor. Hope this helps.

Please rate my advise.

Jan 13, 2011 | 1995 Chevrolet Blazer

1 Answer

I am trying to replace my starter on a 2000 chevy blazer. Where is it located?


follow red wire from battery towards engine/motor it will be attached to the starter motor it should be between the engine/motor and the gearbox/transmission...hope that helps

Aug 30, 2010 | 2000 Chevrolet Blazer

2 Answers

1999 Chevy Blazer Engine will not crank over. All


try turning the key over to the start position. then take a long screwdriver and touch it across the terminals on the starter. this should start your vehicle. if the sarter doesnt turn when you do this,then you have the starter locked up,and yo will have to take it off and install some shims under the bolts.if the starter is trying to turn and the lywheel isnt urning...then you have a locked up engine.

Apr 26, 2010 | 1999 Chevrolet Blazer

1 Answer

97 Chevy Blazer starter relay where is it located and how do I change it


The starter relay is in the engine compartment close to the battery. Its a black or gray box 4" x 4" and may say relays or nothing at all. Lift the cover and get owners manual for exact location inside the box.

Dec 02, 2009 | 1997 Chevrolet Blazer

1 Answer

I need to replace my starter in my 2000 Chevy Blazer. I need help please.


Unhook battery cables from battery locate starter on underside of engine block on the passenger side three bolts to take out replace starter and reverse procedure fairly easy job!! good luck.

Aug 05, 2009 | 2000 Chevrolet Blazer

1 Answer

1999 chevy blazer has trouble starting from a cold crank


If your engine is cranking really strong make sure you have proper engine timing. If your engine is having a hard time cranking like its cranking really slow. You probably need to check your battery.

Apr 30, 2009 | 1999 Chevrolet Blazer

2 Answers

1999 Chevy Blazer 4WD wont start


Sounds like the bendix is stuck in the starter. When this happens, the starter energizes and turns, but the gear does not kick out to make contact with the flywheel. Have someone tap on the starter while cranking the engine.

Dec 25, 2008 | 1999 Chevrolet Blazer

Not finding what you are looking for?
1999 Chevrolet Blazer Logo

3,043 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

70346 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22041 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6869 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...