Question about 1995 Jeep Cherokee

1 Answer

Actuator issue 95 Jeep Grand Cherokee

PDLs keep actuating open and closed sporadically while driving vehicle or sitting stopped at lot. Going over bumps it's worse. Is this a bad actuator or something else?

Posted by on

  • sherrytrans Oct 29, 2008

    Thanks, Mikey108 for the suggestion...it was much appreciated!

×

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

    Sergeant:

    An expert that has over 500 points.

  • Expert
  • 475 Answers

Check the wiring harness between the drivers door and the "a" pillar

Posted on Oct 29, 2008

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2009 jeep grand cherokee transfer case actuator


it says service it , I'm not sure that means to replace it . get a second opinion from a reliable mechanic , NOT THE DEALER

Mar 07, 2014 | 2005 Jeep Grand Cherokee

1 Answer

The lift gate window wont open


Did you ask the dealer's Service dept to run your VIN number to see if there are any TSB's on your vehicle for this or any other problems.
Chrysler sends out Technical service bulletins to dealers, Where they found a problem with a part, Then sends dealers the info on repairs that will be covered.

Jan 29, 2014 | 2012 Jeep Grand Cherokee Laredo 4dr SUV...

1 Answer

My 95 jeep grand cherokee larado and reverse stoped working but it is goin in to reverse just not going barkward and its making a sound in the bellhousing


Obvious transmission issue. Bad reverse clutch unlikely, but it is probably fluid related. Auto transmissions are fluid actuated machines. IF the juice is not flowing , it will stop functioning. Aside from possible massive internal damage, it may just be a bad gasket. What have you observed under the vehicle?

Oct 28, 2013 | Jeep Grand Cherokee Cars & Trucks

2 Answers

Stuck in four wheel drive


Hi there:This is a common issue on this model vehicle quite a few times is the transfer case electric shift actuator can fail/short and when this happens it shorts out the 4wd computer internally making it to where both the actuator on the transfer case and the 4wd computer need replaced.

First, before to change or replace some parts, you will need to be done from here is to have the fault codes read out of the 4wd computer with a scan tool that can communicate with this computer,once this has been done then it can be diagnosed as to what is at fault and then repaired from there.

Keep in mind that TCCM is a different computer then where you would read fault codes for the transmission,the codes need checked using a scan tool that can read the TCCM. It is located under the center of the dash near the steering column (rigt side I thnik).
Hope this helps; also keep in mind that your feedback is important and I`ll appreciate your time and consideration if you leave some testimonial comment about this answer.

Thank you for using FixYa, have a nice day.

Jun 24, 2012 | 2003 Jeep Grand Cherokee

1 Answer

2000 JEEP GRAND CHEROKEE


un screw actuater from plenam raise off mounting tabs and see iff door moves freely in both directions to open and closed positions if it does and it feels like the door is in tact it is more than likely the actuater

Mar 30, 2012 | Jeep Cherokee Cars & Trucks

1 Answer

I have a 1999 jeep grand cherokee and the heater is hot on the drive side and cold on the other side


Assuming you are going to replace the 99/04 Jeep Grand Cherokee blend doors yourself.
You would start by disconnecting the negative battery cable.
If you are going to remove the dashboard, etc to replace the blend doors.
some websites give you complete instructions with plenty of pictures.
It will take the average person with little or no auto repair skills approximately 12 to 16 hrs.
The vehicle will have to be taken to a shop that can recover the refrigerant before you start removing the dashboard and HVAC box..

If you are going to do the type of repair where you cut an access hole in the side of the HVAC box.

A short version of how the access hole repair is done.

Disconnect the Negative battery cable.

Lower the glove box

Remove the actuator motor - You will need a Phillips screw driver

Cut an access hole in the plastic HVAC box - Use a multi-purpose cutting bit, you will need a rotary type of cutting tool, like a Dremel, RotoZip, etc. Or you could do the cutting by hand with any type of small cutting tool, it will just take longer doing it by hand. Or some people have used a narrow pointed soldering iron!

Remove the broken blend doors

Install the new blend doors.

Replace the actuator motor.

Close the access hole - Replace the wall piece of plastic you cutout -Use foam tape or an aluminum tape to cover the groove made by cutting the wall.

Close the glove box.

It is almost as easy as what you just read, the hardest and the most time consuming thing to do is cut the access hole.
The job should take between 30 minutes to 1 ½ hours. Depending on how long it takes you to gather your tools, etc.

Dec 07, 2010 | 1999 Jeep Grand Cherokee

2 Answers

How do i fix the power windows?


are they power or ? this could be a fuse problem, actuator, or motor problem

May 01, 2010 | 1995 Jeep Grand Cherokee

1 Answer

Right rear door lock won't unlock, can't open door


bring a long hook and slip it keep trying until you hook with actuator rod and pull it and the door will open

May 31, 2009 | 2000 Jeep Grand Cherokee

1 Answer

Noisy power lock alert on 99 Jeep Grand Cherokee


It is a door lock actuator. Actuate the locks with both the driver and passenger switch and all doors open to determine by sound which one it is. The actuator is incorporated in the door latch assembly.

May 02, 2009 | 1999 Jeep Grand Cherokee

Not finding what you are looking for?
1995 Jeep Cherokee Logo

Related Topics:

56 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

70387 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22041 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6878 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...