Question about 2002 Mitsubishi Lancer

1 Answer

Mitsubishi magna sterio wires

I am trying to install an new head deck in my mitsubishi 95 magna ts se. i cant find the power, earth and battery wires in it. i had three wire outbut when they touch, i had the car turned off, the dack lights came on. which wires r which?

Posted by on

  • Anonymous Mar 12, 2014

    what oil for auto gearbox in Magna TR SE

×

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 53 Answers

First of all you should always use a wire harness when installing a unit into a vehicle you should never cut the factory harness but guess you already did so here is the wire diagram for your car hope this helps http://www.installdr.com/Harnesses/Mitsubishi-Wiring.pdf

Posted on Sep 24, 2008

×

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Installing sterio


Buy an installation kit to ensure proper connections...

Also, don't buy a DUAL deck...junk

Jan 03, 2014 | 1986 Mercury Grand Marquis

1 Answer

I need a radio wire diagram for a 1988 Mitsubishi colt GLX re!


What unit was fitted to the vehicle. I have an 1988 RD colt that had the factory AM/FM radio. This had a 6 pin connector and it works out easier to use the power and earth of the original connector and install new speaker wiring for the following reason. The AM/FM radio didn't need specific polarity for the speakers so it used 4 positive wires to the speakers the negative terminal of the speaker was then earthed to the body. This set up is not suitable for modern head units and will damage the integrated circuits. Therefore you will have to run new wiring to the speakers. You will also need to run a new constant power supply as the colt didn't come with this. Hope this helps

Feb 27, 2013 | Cars & Trucks

1 Answer

Fuse keeps blowing to my dash guages in my 95 gmc sierra why?


have you recently installed a new radio ? I have knowen people to install radiosincorectly the dim wire behind the radio shows as a earth. however when you turn headlights on this becomes a positive. if you have wired this wire to your sterio this is whyyour dash lights & internal cab light etc keep blowing.. if your wondering why sterio still works is because its earthed through the aerial or mounting bolts.

Jan 05, 2013 | 1995 Chevrolet Silverado 2500

1 Answer

Oil preaser switch replacement 95 mitsabishi magna station wagon ts


not sure what you wont to know but the sender will be mostlikly near the oil filter,with ignition on short the wire and the oil pressure gauge will read high or oil pressure light will go off youll know you have the wright sender

Aug 14, 2011 | Mitsubishi Mighty Max Cars & Trucks

1 Answer

Cant find power wire in mitsubishi 97 legnum


try using a headlight bulband two peices of wire to make it go and just keep trying evry wire till it lights up. ps make sure battery is connected

Mar 21, 2009 | 1997 Mitsubishi Galant

2 Answers

Help with my mitsubishi magna 1994


Could be a few things.If you check radiator fan and its ok move down to the thermal power switch usualy at the bottom of the radiator.Make sure you have power in and out of the swich when the engine is at operating temp.Use a test light/probe easy to use and cheap to buy.If the switch is ok the next step is the relay in the box with lid next to the battery.Sometimes just pulling the relay out and putting back in will fix the problem due to poor contact.To sum up its usualy the thermal temp switch but check every thing else before wasting money on the wrong things.Good luck

Nov 08, 2008 | Mitsubishi Lancer Cars & Trucks

2 Answers

2001 triton wiring


you need to check your fuses in the car under the dash by drivers door in fuse box and under the hood.

Sep 04, 2008 | 1988 Mitsubishi Pickup

2 Answers

Mazda 323 1996 Alternator Wireing.


Hi,i am from greece and i want bigger front brakes for to my mazda 323c 1.3 cc 16v, mod.95. Can i use from another mazda model and which is that?

Jul 29, 2008 | 1986 Mazda 323

2 Answers

Starting problem


check your starter motor wiring first there should be a wire of aroung 5mm thickness bolted to the starter solenoid that is your power from battery the other is one small wire which clips on, this one tells it to"go" when you turn the key if either is loose it will work sumtimes, also check your battery connections are secure and motor to car earth(s) are secure

May 30, 2008 | 1995 Mitsubishi Diamante

Not finding what you are looking for?
2002 Mitsubishi Lancer Logo

750 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mitsubishi Experts

yadayada
yadayada

Level 3 Expert

70387 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22041 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6879 Answers

Are you a Mitsubishi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...