- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
The answer is yes, any 5-speed from a 94-04 Mustang (4.6 or 3.8 doesn't matter, it's the same transmission). You'll also need the pedal assembly, shifter assembly, ecu from a 5-speed, 5-speed drive shaft, clutch and clutch cable, and flywheel. BUT, If u didn't know all that already... let alone the yes or no answer to ur question, I wouldn't advise doing an over
sorry, i only have 94 whcih is probably different. Hope it helps at least some.
Section 17-01: Lighting, Exterior
1994 Mustang. Workshop Manual
REMOVAL AND INSTALLATION
WARNING: THE REPLACEABLE HALOGEN HEADLAMP BULB CONTAINS GAS UNDER PRESSURE. THE BULB MAY SHATTER IF THE GLASS ENVELOPE IS SCRATCHED OR THE BULB IS DROPPED. HANDLE BULB CAREFULLY. GRASP BULB ONLY BY ITS PLASTIC BASE. AVOID TOUCHING GLASS ENVELOPE. KEEP BULB OUT OF REACH OF CHILDREN. Removal and Installation
Place the headlamp switch (11654) in the OFF position.
Remove the electrical connector from the miniature bulb (13466) by pulling it rearward.
Remove three nut and washer assemblies from the rear of the headlamp (13008) .
Remove the headlamp by pushing forward on the headlamp bulb and retainer (13N021) assembly. For ease of removal, it may be necessary to loosen the attachments of the adjacent parking lamp (13200) and cornering lamp assemblies.
Remove the three clips attaching the headlamp to the headlamp bulb retainer (13N019) by prying them out from the base using a flat-blade screwdriver. This completes the removal of the headlamp . Save the clips for the installation of the new headlamp .
To install the aerodynamic headlamp , ensure that the black rubber shield is securely crimped to the headlamp , then reverse Removal procedure.
After headlamp installation, check headlamp aim and adjust as necessary as outlined under Adjustments.
Turn headlamp switch on and check for proper operation.
Parking Lamp Assy
Headlamp Dash Panel Junction Wire
Nut (2 Req'd)
Headlamp Adjustment Screw and Nut Assy
Tighten to 4.4-6.4 Nm (39-57 Lb-In)