Question about 1995 Lincoln Town Car
If you have the owners manual it may tell you in there.Thats where I found mine for my camery.
Posted on Sep 23, 2008
It is located on the left frame rail in front of left rear tire.It has a plastic clip in each fuel line that will be white in color.Remove the clip then disconnect fuel line.Make sure to replace the clips,DO NOT reuse the old ones. Install the new clips into the connector then snap the connectors on to the filter.
Posted on Mar 01, 2009
Hello Callahan5922....this sounds like a stuck blower motor resistor. I assume the blower won't function in the a/c mode either? If you have a digital multimeter you can check this. I believe it's fuse #2....if the digital indicator goes up or down when you increase or decrease the fan speed thats good. Locate the blower motor resistor....you wil find it located on the fire wall behind the right valve cover hiding behind the heater hose, it's about the size of a cigarette pack. With the engine off, and key in on position, turn the A/C on High, and rap a tap tap tap on the resistor. You might be suprised when the blower motor takes off a runnin,
I hope this is the answer you need and i was able to help solve this for you. Good luck...
Posted on May 13, 2009
I will make an assumption here, we know what the root word means. This code was extracted from the computer by? What this is telling you one of 2 things: The Bank 2 oxygen sensor down stream of the catalytic converter (there are 2 converters, one for each bank of cylinders on the 4.6ltr engine) is bad and/or that the Bank 2 catalytic converter is no longer doing the job it was designed to do. Simply, Catalysts wear out. They are good for approx 100,000 miles (as required by Federal Law). Again, I assume that the reason the intake manifold was replaced was because it had a crack in one, or more, of the runners? (part that feeds the head of a manifold). It may have taken a while to find this as being the cause of why the car running incorrectly, maybe rough. This means, that during the time the car was being driven with the problem, the amount of unburned, or not within spec exhaust gases, coming off the side of the engine affected by the intake issue was higher than normal. This out of balance level of exhaust gases were being dumped into the converter on that side of the engine, thus causing the converter to have to run hotter, work harder, or even at the time the gas was being processed through, causing deposits to be formed in the converter, thus shortening it's life span. The Bank 1 side of the engine, apparently, did not have the issue and it's catalytic converter's life was not affected. I hope this makes sense to you.
Posted on Aug 19, 2009
FIRST press and release the setup button to display oil life= xxx
then press and hold the reset button for about 2 sec it should then display oil life set to 100%
Just pressing the reset button when the change oil light comes on while driving will not reset the computer
Posted on Feb 27, 2010
i would recommend something like mobile clean 5000 or Valvoline high mileage oi, im pretty sure that this car takes 10W-30 being the age.
Posted on Apr 06, 2010
Testimonial: "Thanks for your help. I appreciate it!"
Tips for a great answer:
Nov 23, 2014 | 1996 Lincoln Town Car
Apr 06, 2014 | 2005 Lincoln Town Car
Feb 16, 2012 | 2001 Lincoln Town Car
Apr 14, 2010 | 2000 Lincoln Town Car
Feb 15, 2010 | 2007 Lincoln Town Car Signature Limited...
Nov 02, 2009 | 1993 Lincoln Town Car
Aug 14, 2009 | 2007 Lincoln Town Car Signature Limited...
391 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: