Question about 1998 Toyota Camry
Is there a access panel under rear seat for fuel pump
There should be an access panel.
Pull up on the back seat at the front edge to dislodge the locking clips.
Note that the clips can be a really tight fit.
Posted on Sep 23, 2008
1998 toyota camry
My cars check light engine came on, and we went to autozone and got it checked, and it come back as a short/poor connection. Also whenever I turn on my head lights the reverse and trunk open lights come on. Is there anyway to find this short without pulling my whole car apart or has anyone had this problem before?
Posted on Oct 09, 2008
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
Tips for a great answer:
Dec 11, 2017 | Nissan Cars & Trucks
Dec 30, 2015 | 2002 Oldsmobile Alero
Jul 14, 2014 | 1997 Subaru Legacy
Nov 07, 2013 | 1988 Honda Civic 2 Door
Jun 25, 2011 | 1996 Toyota Camry
De-pressurize the Camry's fuel system. With the gas cap open (to release pressure in that location), open the fuse/relay panel under the hood and remove the relay labeled "C/OPN." Start the engine and let it run until it stops. Disconnect the battery's negative cable.
Detach the rear seat from the car. Lift up the front edge of the seat bottom cushion, disconnect the mounting bolt underneath and remove the cushion. Pull up the seat back locks, flip the seat backs down and remove the mounting bolts.
Remove the service hole cover from the floor under the seat concealing the fuel pump/sending unit.
Disconnect the fuel line and electrical connectors from the fuel pump unit. Remove the retaining bolts and withdraw the unit carefully out of the fuel tank.
Release the clips on the fuel pump assembly's plastic support with a screwdriver to remove the support. Then pull off the rubber isolator, remove the fuel sock filter and disconnect the electrical connector from the top of the assembly. You can now withdraw the fuel pump from the housing.
Connect the new fuel pump into place on the assembly housing. Reassemble the fuel pump/sending unit in order, from the electrical connector to the fuel sock filter, rubber isolator and bottom plastic support.
Place the pump unit back within the fuel tank and reattach the bolts. Reconnect the electrical connectors and the fuel line. Reattach the rear seats.
Replace the "C/OPN" relay, reconnect the negative battery cable and fill the fuel tank if it is empty.
Pressurize the Camry's fuel system by turning the ignition on for a couple of seconds. Then turn it off for ten and repeat this five to ten times.
Jan 02, 2011 | 1996 Toyota Camry
Dec 10, 2010 | 1989 Toyota Camry
Oct 11, 2009 | 2000 Mitsubishi Mirage
Mar 18, 2009 | 1992 Toyota Camry V6
269 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: