Question about 2003 Chrysler Concorde

1 Answer

Moonroof The moonroof has developed a mind of its own. The other day it vented by itself when it had not even been used for a couple of days. I'm not able to get it to close now. I can get the vent position to change a small bit but will not close completely. Also since it will not close from the vent position I'm not able to get it to the full open slide. Is this a switch or motor issue and is there any way to disconnect so it will close without fixing whatever the problem is?

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Brigadier General:

    An expert that has over 10,000 points.

  • Master
  • 5,158 Answers

Change the relay for it...


Robert

Posted on Sep 23, 2008

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have 2000 gran marquis custom moonroof vent stuck open no power where is motor located?


There should be an access door on headliner.if not, you'll have to remove, lower headliner...I would start at the fuse panel and make sure the fuse is ok

Mar 13, 2014 | 2000 Mercury Grand Marquis

1 Answer

Moonroof will not vent or seal shut. Why?


It sounds like a mechanical adjustment. A lot of times moon roofs will have adjustment screws to make small alignment adjustments. You may have to move the glass to various positions to access them, but that is where I would start.

Jun 18, 2013 | Ford Fusion Cars & Trucks

1 Answer

How do i fix a code 0449 on my 2010 impala


Hi there:
There is a vent solenoid in the back left (drivers) side on the inside of the fender by the filler tube where the gas goes to the tank. Just replace it on Chevy cars for this code, it's called an Canister Vent Solenoid or EVAP Vent Solenoid.



Usually this is a bad vent solenoid or a broken wire going to it; You would need a lift. The vent solenoid is near the evap canister which is tucked up into the body by the gas tank. I dont' think you can even see the wires without pulling the canister down...


9_11_2012_5_03_35_pm.gif

Hope this helps; also keep in mind that your feedback is important and I`ll appreciate your time and consideration if you leave some testimonial comment about this answer.

Thank you for using FixYa, have a nice day.

Sep 09, 2012 | 2010 Chevrolet Impala

1 Answer

Subaru outback moonroof won't close moonroof vent stuck on passenger side



If this occured after trying to close the shade while the moonroof was opening, it is possible that the plastic tab that locks into the vent (and subsequently the rest of the moonroof) has been bent. I was having a similar problem where my vent would only go up on one side and stay closed on the other (and it would sometimes get stuck open). It would also prevent the rest of the moonroof from opening up. If this is the case, from what I can tell, there is no easy fix for this. Upon researching this problem, you are the only other person asking about it and zero fixes. For the time being, the vent can be closed by lifting up on one side to "unlock" the stuck tab and you should be able to put it down. After that, you should look up instructions to remove your moonroof glass to see if you can inspect the affected area to determine the cause. Here is a link that shows you how to remove the moonroof glass, but does not address the exact issue you describe.

Jun 17, 2012 | 2005 Subaru Outback

1 Answer

What fuse number is for sunroof


I don't really see a dedicated fuse or circuit breaker for the moonroof. I do see a 30 amp circuit breaker for the mmonroof but that also controls the power windows and the sliding back light as well as the moonroof, so if you're not having problems with the other stuff I would say it's not the circuit breaker. There is a 10 amp fuse for the delayed accessory power for audio, power door lock switch & the moonroof switch illumination. The 30 amp circuit breaker is located in the number 401 position in the passenger compartment fuse box (see picture below) and the 10 amp fuse I was telling you about is in the number 22 position. If it's just the moonroof itself I would check to make sure the switch itself is good or even the motor could be bad. I see no fuseable link going to the switch but that's not saying there may be a bad wire so check for power to the switch. Wish i could have been a little more help but in this case this is all I can give you. I hope this helps and good luck. Here is your picture:


clifford224_138.gif

Apr 12, 2011 | 2004 Ford F150

1 Answer

What to know if sunroof only slides open or if it will pop up to open like preludes


On EX and EX-V6 models:
The moonroof has two positions: it can be tilted up in the back for ventilation, or it can be slid back into the roof. Use the switch under the left dashboard vent to operate the moonroof. The ignition switch must be ON (II).
To tilt up the back of the moonroof, press and hold the center button. To close the moonroof, press and hold the top of the switch To open (slide back) the moonroof, press and hold the bottom of the switch. Release the switch when the moonroof gets to the desired position. Make sure everyone's hands are away from the moonroof before opening or closing it.
The moonroof has a key-off delay. You can still open and close the moonroof for up to ten minutes after you turn off the ignition. The key-off delay cancels as soon as you open either door. You must then turn the ignition ON (II) for the moonroof to operate.
Hope this helps.

Nov 02, 2009 | Honda Accord Cars & Trucks

1 Answer

Compurter says PSM and ABS failure - Porsche Boxster 08/2002


Hi,

Just had same problem this morning. I had noticed that the satnav was malfunctioning (i.e. developed a mind of its own!!) a couple of days ago and then this morning PSM/ABS failure......marvellous!! Anyway, simply disconnected battery, waited 10-15 mins, reconnected battery and hey presto my boxster fired up. However the PSM failure message still showed, so took it for a spin around the block and the message disappeared and, touch wood, everything seems back to normal. I think it must have been a battery problem, so just to safe I am going to get a new battery and hopefully I can look forward to years of trouble free motoring.....one day with the roof down!!!! (Where has the sunshine gone!!!????)

Jun 28, 2009 | 2005 Porsche Boxster

1 Answer

Audi 1996 A6 wagon - battery drains if car not used for 4-5 days


unhook the battery completely and see if it will start after a couple of days. if it does you probably have a wire stripped and grounded out. all you need to do is install a power disconect key in the car, and you wont have any more problems.

Feb 10, 2009 | 1996 Audi A6

Not finding what you are looking for?
2003 Chrysler Concorde Logo

Related Topics:

148 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

70365 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22041 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6878 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...