Question about 1995 Ford Ranger Supercab

2 Answers

1995 ford ranger 3 .0 number 5 spark plug wet with fuel have changed injectes blowing bleu smoke

Posted by on

2 Answers

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

My name is laurence and i need an answer for why my center support bearing makes the front drive shaft too short and will not meet the rear drive shaft now. Sorry for busting in but i'm at my wits end and really need some help. would have went to sevice center but cash is low. gotta get this fixed! please help somebody!

Posted on Dec 20, 2008

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 29 Answers

It can possibly be oil getting into the piston fire area. Maybe a leaky valve seal, or head gasket? Possibly rings?

Posted on Sep 23, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1994 Ford Ranger low power


Ok, it sounds as though your fuel pressure regulator or injector lines or injectors are leaking. What engine is in the vehicle? Is the engine light flashing? Does it start hard and blow smoke on startup?

May 31, 2014 | 1994 Ford Ranger Supercab

2 Answers

Black smoke


Is it a turbo engine. What size engine. How old is the car.

Dec 09, 2013 | Ford Ranger Cars & Trucks

1 Answer

My 88 ford ranger with 2.9 electronic fuel injection is missing real bad and backfiring and dont even have enough power to climb my drive way i adjusted the timing changed fuel pumps and distributer a


Check that you have the plug leads on the distributor cap the right way around and that the cap and rotor are in good condition and secured properly.

Nov 06, 2012 | 1988 Ford Ranger

2 Answers

Change my spark plugs and distrubutor cap and the 85 ranger want start


You may have got the spark plug wires out of sequence.
Reseat the coil wire going to the center of the distributor cap Check the spark plug wires at the distributor against the firing order as follows:
The spark plug firing order is 1 - 4 - 2 - 5 - 3 - 6 The distributor rotor turns CLOCKWISE The engine cylinders / spark plugs are numbered :
firewall 3 - 6 2 - 5 1 - 4 front
Best wishes,
TF

Jun 03, 2011 | 1985 Ford Ranger

1 Answer

Old '87 ranger been sitting in folks yard few years. fires up fine, but spits and sputters going down the road


Old fuel in tank, fuel filter clogged, plugged/clogged carb. or fuel injectors.

1. Drain fuel from tank and replace with new fuel with SeaFoam or Lucas

2. Repace fuel filter

3. With engine running at a high idle and air cleaner off, spray or pour carb/fuel injection cleaner into carb/fuel injectors.

If problems persist, check plug wires for cracks and/or breaks. Pull spark plugs checking for fouling.

Apr 09, 2011 | 1987 Ford Ranger

1 Answer

What is the firing order on a 92 Ford ranger xlt 3.0 v6


The spark plug firing order is ( 1 - 4 - 2 - 5 - 3 - 6 ) The distributor rotor turns CLOCKWISE ( 1 - 4 - 2 - 5 - 3 - 6 ) The marked # 1 position on the distributor cap faces towards the firewall and slightly towards the passenger side The engine cylinders / spark plugs are numbered : passenger side of engine , front to rear , 1 , 2 , 3 and drivers side of engine , front to rear , 4 , 5 , 6

Dec 08, 2010 | 1992 Ford Ranger

1 Answer

1986 ford ranger sputtering and stalling out?


your having a weak spark issue you will need to remove your distributor to replace the pickup or the coil is breaking down sometimes this can be the egr but be careful removing this as not to break the intake hope this helps
p.s i had one with 2.9 and cured this problem on mine pick up in dist was weak but this could be emission also have any codes? good luck

Feb 11, 2009 | 1986 Ford Ranger 2WD

1 Answer

No spark at all!


you need to check the fuses again under the hood and under the dash if all are good look for a bad fuse link if you melted wires you had to blow fuses or fuse link

Dec 22, 2008 | 1998 Ford Ranger SuperCab

1 Answer

Ignition wiring


firingorder6a.gif firingorder6.gif 1991-1994 2.9L and 3.0L Engines Firing Order 1-4-2-5-3-6 1995 And Later 3.0L V-6 With DIS Ignition System Firing Order 1-4-2-5-3-6
4.0L Engines Firing Order: 1-4-2-5-3-6 DIS Ignition System

Nov 22, 2008 | 1995 Ford Ranger Supercab

Not finding what you are looking for?
1995 Ford Ranger Supercab Logo

182 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

60867 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Fordexpert

Level 3 Expert

5331 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...