Question about 1994 Suzuki Swift

2 Answers

Engine is missing at driving speed range. fuel filter is fine timing is fine and only does it in the morning but the engine is warm.

Posted by on

Ad

2 Answers

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

By playing with the slotted switch on the side of the carburator ,(under the air intake duct) i solved my problem, just loosenen the 2 screw and move it to lowest idling rpm so that the engine run smooth.
have a nice day Eric

Posted on Oct 09, 2008

Ad
  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 2 Answers

Problem must be due to clogged injectors and fuel pump.pls have injector cleaned .

Posted on Sep 24, 2008

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Hi, i hope that i can get some help from anyone in this forum, i havin problems whit my Dodge Dakota 2004 6cil 3.7 lts, the thing is that i have a misfire at idle and the p0300 code comes on, the truck...


You did everything I will suggest in normal case.only one step you miss!
Remove the crank sensor and stick 4 layer of masking tape,turn the engine to point were the ring is full(no hole)and install the sensor again.Use scan tool and learn the new position of the sensor.when the sensor move the timing move to ,if your flex plate is lose or damage will give the wrong angle for cyl.#1 After computer register misfire wil go to fail safe mode and set the timing to 10 degree
good luck

Oct 11, 2014 | Cars & Trucks

2 Answers

Cold start low ideling


You can in most cases repair this slow speed stall or unstable idle by cleaning the engine throttle valve and the idle speed control valve using a product called CRC Spray Throttle valve cleaner. Spray the cleaner into the air intake of the engine with the hose removed from the throttle body, the engine will try to stall so hold up the idle speed manually. Once you have used up about 1/2 can of the cleaner stall the engine out while spraying and turn the key off, disconnect the negative battery cable for 5 minutes and then reconnect and drive the car for a about 25 miles of varied driving modes. If this doesn't cure the problem you may need the fuel injectors professionally cleaned by the dealer service dept.

May 19, 2017 | Mercedes-Benz Mercedes 190E 2.3-16 Diecast...

2 Answers

1998 ford escort zx2 car runs great till it reachs normal operating temp range then it misses like crazy. put in a new fuel pump that didnt help tried new coil pack that didnt help either its not over...


ignition module , that the coil packs sit on ,was the problem on my car. had the same symptoms .ran fine till it warmed up then it started missing like crazy

Nov 03, 2013 | 1998 Ford Escort

1 Answer

97 dodge dakota. 2.5 , 5 speed, 2wd, 110k . I have replaced - dist. cap, rotor,wires, plugs, fuel pump, fuel filter, # 4 injector, tps, crank pos sensor, air filter. Truck will start and run fine until...


How about the pick up coil in the distributor? A trick we used to use back in the day was to tap the distributor housing with a hammer, key word tap. If the engine missed or stalled than the pick-up coil was replaced.

Oct 27, 2010 | 1997 Dodge Dakota

2 Answers

My 2003 f 350 7.3 wont start in the morning missing out runs better when it warms up but still misses out rebuilt motor an had valves done an same results please help


HARD START PROBLEMS WITH A DIESEL ENGINE GLOW PLUGS RELAY FAULT BUT ENGINE MISS COULD BE LOW COMPRESSION OR AIR LEAKS IN THE FUEL SUCTION LINES.HAVE FUEL FILTER REPLACED SEE DOES IT HELP.

Aug 23, 2010 | 2005 Ford F 350 Super Duty

2 Answers

Holds idle fine but stalls when accelerating


your carburetor should have a fuel filter in the carburetor body where the
fuel line enters it replace it and, any other in-line fuel filter the engine might have

Jul 25, 2010 | 1986 Jeep Cherokee

1 Answer

Intermittent misfiring


Had the same thing. The didtributor was going bad. Lived with it for a few months finally it died. 1 year after replacing the distributor the problem started again. Glad I got a warranty on the distributor. Running great now on the second distributor.

Jul 08, 2010 | 2001 Mitsubishi Diamante

1 Answer

Have a 2005 escape this morning it was cold. and


Have your fuel pressure checked.And change the fuel filter.

Nov 29, 2009 | 2005 Ford Escape

1 Answer

94 j-30 sometimes missing runs rough then 1 hour later runs fine


Check to see if your spark plug wires are not cracked or worn. They would make the engine run rough when cold or damp more often then when the engine drys up when warmed up- just an easy thing to check...

May 24, 2009 | 1997 Infiniti.5 J30

1 Answer

Engine Missing / Hesitation Cold Weather


run the fault codes
check for problem ambient temp sensor, baro sensor , maf/vaf sensor problems

Apr 07, 2017 | 2002 Chevrolet Silverado 1500

Not finding what you are looking for?
1994 Suzuki Swift Logo

Related Topics:

244 people viewed this question

Ask a Question

Usually answered in minutes!

Top Suzuki Experts

yadayada
yadayada

Level 3 Expert

78238 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Boyet Soriano
Boyet Soriano

Level 2 Expert

293 Answers

Are you a Suzuki Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...