Question about Hyundai Accent

1 Answer

2000 2 door accent removed airbag fuse (mistake) when replaced the dash warning light for Airbag now stays on it flashes as normal when vehicle started but then is steady on

Posted by on

  • 1 more comment 
  • Anonymous Mar 14, 2014

    Warning light and aibag light on steady.

  • Anonymous Mar 17, 2014

    I have a 2003 Hyundai Accent and the airbag light stays on. What is causing it to stay on?

  • Anonymous Mar 17, 2014

    I have a 2003 Hyundai Accent and the airbag light stays on what does that mean??

×

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Master
  • 1,263 Answers

You have to reset the ecm code , when you removed the fuse the ecm registered this as a loss of voltage and threw a code so now it doesn't know that the fuse has been replaced. you need a scan tool to reset the ecm...please rate the solution...thanks

Posted on Sep 22, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

B1801 Ford Escape 2002. The air bag light comes on the instrument panel in my vehicle and will stay on for a while then go away. I had someone test it for me and told me it was code B1801. It was at a...


Did you disconnect the battery recently...did you operate the horn.both questions related to what may originally cause the airbag warning light to stay on.if it was the battery being changed reconnected then you have to reset the airbag light.this is quite simple on Fords.
with the engine off ....ignition key into the lock open the drivers door and keep it open ....locate the button at the bottom of door for courtesy light....hold your finger on it...turn the ignition on so that only the lights on dash come on...do not start car....now press the door button 6 times within ten seconds and on the last count of six hold it in whilst turning off the ignition.then close the drivers door and start.the airbag light usually flashes for several seconds then it should clear.on some model fords the button press count is 5 or 7 so you may need to repeat ....on mine I discovered I had to open the passenger door after the procedure before turning ignition back on.a word about the horn.on older model fords the springs that sit in the horn housing also affect the sensor of the airbag in some models .the springs gets rusty or bunged up and operating it will cause the airbag sensor fault.never attempt to remove the cover of the horn assembly as you may fire off the airbag.just remember to reset the warning light... And get a mechanic to look at the horn if it continues to play up.Please remember if the airbag warning light is flashing it may mean the airbag will be disabled and will not deploy in the event of an accident, this also means the seatbelts may not lock on impact either.please vote if helpful thanks.

Feb 27, 2015 | Ford Cars & Trucks

1 Answer

Airbag deploy


To deploy an airbag you have to put the vehicle into high g manouver like a collision. And after that the vehicle is damaged. Why do you want to deploy the airbag? You can remove it as a single unit, but the vehicle airbag warning light will then stay on all the time. Why would you want to remove it?

Dec 20, 2013 | 2005 Pontiac Montana SV6

1 Answer

Ford focus estate airbag lights


Try going to an Autozone, Advance, or Oreilys autoparts store for a free scan. They may have a scanner which will read this warning and actually tell you what part is bad.

You may have a dirty bumper sensor(First try wd40 on it) or a problem with the airbag triggers inside the dash. Do not fool with the dash. It can deploy the airbags and then you are looking at injury and hundreds of $ to replace them.

Also, do not ignore the warning.

Feb 03, 2012 | Cars & Trucks

1 Answer

The airbag warning light flashes


First check the airbag or SRS fuse if blown replace if not you will need to take the vehicle in to either the dealer or a shop that has the appropriate SRS diagnostic equipment. When the airbag light is on or flashing it indicates the SRS system is disabled and major fault is present. There are many causes from component failure due to age or accident, to a blown fuse. Check your owners maual for the location of the fuse.

Sep 05, 2011 | 1993 Ford Econoline

1 Answer

2007 Sienna airbag warning lamp flashing


Certainly check with your Toyota Dealer as the vehicle is hopefully is still under factory warranty at that milage. The Air bag light flashing is certainly cause for concern, and having an airbag set off without impact can be very dangerous and it is best to have a professional working on your airbag issues.

Dec 13, 2009 | 2000 Toyota Sienna

1 Answer

Air bag warn light Engine warn light Car runs great . Why are these signals coming up on the dash ?


dear friend-plse note that the airbag warning light will not affect the preformance of your vehicle.the engine management light has nothing to do with the airbag light,what saying is that you got two different problems,i think you need to disconnect the battery for a while,reconnect and check if lights is of, if it re-appears plse then hook up to a scanner to read the code"s

Sep 28, 2009 | 2003 Hyundai Accent

1 Answer

2000 ford windstar airbag light flahes then stays on


You should take the vehicle to a certified dealer immediately; Your airbag could deploy prematurely causing serious injury or death!

Mar 31, 2009 | 2002 Ford Windstar Cargo

1 Answer

Airbag light on instrument panel flashes then stays illuminated


Some vehicles you can disconnect the battery for 10-20 mins and it usually resets a check engine light. But the airbag light is different. This means there is something wrong with the airbag system and it will not go out until maintenance.

Mar 29, 2009 | 1999 Ford Explorer

3 Answers

1997 Dodge Caravan Horn and Airbag light


It's the " clock spring " . Dodge has a lifetime recall / replacement on this part. Somehow it controls the air bag and is tied into the horn and cruise control .

Jan 12, 2009 | 2000 Dodge Caravan

1 Answer

Can I disable my passenger side airbag?


Pull your airbag fuse out (It might be labeled Airbag, or SRS)
This will have your airbag warning light stay on in your dash, until you put the fuse back in.

WARNING : I did NOT tell you that... Don't worry there is no way the air bags can go off just by removing or replacing the fuse, but I'm just covering my bases here. In the event of an accident, I don't want to be the guy that told you to pull the fuse out (this disables both air bags), if you do pull the fuse you are responsible for that action if, god forbid, something happens.

Aug 12, 2008 | 1998 Mercury Sable

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

313 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hyundai Experts

yadayada
yadayada

Level 3 Expert

60769 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you a Hyundai Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...