Question about 2001 Ford Expedition

1 Answer

2001 ford expedition

The 4x4 light is blinking along with the abs light and the blinkers stopped working

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 15 Answers

This is all electrical. Sounds like a fairly big job. Blinkers and ABS usually run from same fuse and therefore same wiring. Not sure of the 4x4 light. But Id say if you get a wiring diagram and folloe from the 3 items back there would be a common wore and id say in your case this wire is loose, or semi broken. However I think it would be less stress if you simply go to an auto electrician, Good luck, hope this helps.

Posted on Dec 31, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Eddie Bauer. Why did 4x4 light start flashing and turn signal will not work anymore?


Start by checking the fuses in vehicle and then fuses and relays under hood. Hope that helps.

Dec 04, 2015 | 1999 Ford Expedition

1 Answer

My blinkers will just stop working. I just had a new multi-function switch replaced and it is still doing it. I can manually turn the blinker off and on and the blinker light works.


Hi,
Looks like the blinker relay needs to be replace! It blinks once and stop, means the relay bi metal is burned and have to be replace.
hope that helps you out!

Jun 09, 2011 | 2004 Ford Expedition

1 Answer

I have a 2004 Ford Expedition 4.6L XLT. My brake lights do not work when I push on the pedal. My top brake light doesn't light up at all. The lights for the other two light up when I turn on my lights,...


I am having a simliar problem! Mine is when I put the blinker on and apply the brake my blinkers don't work & then when I put my right blinker on my left and right one blink @ the same time!

Jan 13, 2011 | 2004 Ford Expedition

1 Answer

After my 2001 Eddie Bauer Expedition warms up...


well i have heard that the front hubs are known to go bad in the 4x4 pickups,which should be the same parts as an Expedition,there may be metal dust on the ABS sensor or the flywheel it reads off from,thats if the hub and or bearings are bad.Jack it up with a jack under the lower control arm just behind the wheel and grab the wheel at the top and bottom and see if there is any movement,that should help explain if the hub is bad if there is alot of movement

Feb 15, 2010 | 2001 Ford Expedition

2 Answers

Ford excursion 4x4 locks and wont unlcock


my4x4 is stuck and can't change back to 2w drive

Feb 09, 2010 | 2001 Ford Excursion

1 Answer

98 expedition trailer brake and blinker lights stopped working


check you bulb and there sockets its possible that you burned out one of the two

Aug 20, 2009 | 1998 Ford Expedition

1 Answer

P2106 code appeared when I put my truck up to the diagnostic.


mass air flow meter will effect your performance.Change that first.

Jul 17, 2009 | 2004 Ford Explorer

4 Answers

Ok well my 2001 ford expedition was running perfect until yesterday i get in it and it would not start so i tried to get a boost off but my battery is only two months old the radio works the lights and...


Do you happen to have more than one Ford Key on your key ring. The theft system on this is a transponder system and it could get the wrong signal from a key to a different vehicle.

Mar 14, 2009 | 2001 Ford Expedition

Not finding what you are looking for?
2001 Ford Expedition Logo

276 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

60960 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Fordexpert

Level 3 Expert

5331 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...