SOURCE: How do you reset a low tire pressure warning on a 2008 Jetta?
Reset the tire pressure warning, same as you would any service issue. Insert key in ignition, hold wrench button and min button, then start engine.
SOURCE: Error message "svc tire monitor"
The owners manual will not give the following information but chapter 3 around pges 40 -49 will tell you how to get into tire monito learning section. 1. Take all four valvestem caps off. 2. Find a tool such as a small diameter philips screwdriver that will work to let air out of the valvestem. A common aluminum 1/8" rivet (round end into valve stem) works very well. 3. Add air so that the tire pressures are all 40+ psi (do not exceed the tire's max. inflation rating on the sidewall). 4. Turn key to on position. 5. Apply parking brake. 6. Press and hold lock/unlock down at the same time (for about 3 seconds) on the key fob until the horn honks and left front park light flashes. Without keyless or remtoe entry fob use the Driver Information buttons on the left of sterring wheel. Press and hold bothe DIC and reset button at the same time for abot 10 seconds this will bring up the personal menu use DIC button to get to Tire monitor menu press and hold reset button untill horn honks and left front light flahes then continue with step 7. 7. Start at the LF tire. 8. Let air out for 4 seconds - count it out (one one-thousand, two one-thousand, three one-thousand, four one-thousand). 9. Wait for about 15 seconds* for the honk (sometimes it'll honk right away). 10. Repeat 7 and 8 for the RF tire. 11. Repeat 7 and 8 for the RR tire. 12. Repeat 7 and 8 for the LR tire. 13. With all four now done, the system will give it's final multi-honk completion note. 14. Use a quality gauge to set your final pressures (a good gauge will exactly match the sensor readings). 15. Replace all four valvestem caps. *If you've waited fifteen seconds for the honk and nothing has happened. Don't panic - Simply repeat 8 and 9 again as there is a two minute window to do each tire sensor.
SOURCE: how do you replace low beam headlight on 2008
Access to change the headlamp bulbs is through the wheel well. The recommended method is to remove the front tire and then the plastic inner fender liner. Once removed, you'll have easy (more or less) access to the rear of the headlamp housing.
SOURCE: How do you reset tire pressure monitoring system
take one of the battery cables off for a couple of minutes and let the computer reset
SOURCE: what is the tire pressure and the cold tire pressure
This Information is located on the Tires. Look very Closely at the Tire where it meets the Rim. In Black writting there will be the Exact Inflation Specs. If you cannot find them use a Small piece of Chalk to Highlight the Letters and Numbers.
7,356 views
Usually answered in minutes!
Would you please be so kind as to clarify what and where these 2 buttons are?
Could you be so kind as to please clarify where ans what these 2 buttons are? thank you!
sorry, meant and not ans
×