Question about 1990 Oldsmobile Cutlass Ciera

2 Answers

Transmission when i put it in gear " d " transmission slipps, and will creep foward ,but if i start gear :1" then upshift to :"2" then d its fine . its a 94 witha v-6

Posted by on

2 Answers

  • Level 1:

    An expert who has achieved level 1.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 4 Answers

You have to change first the ATF and filter after that you have to check the transmission vacum i hope it will be good after that

Posted on Nov 10, 2008

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 39 Answers

Sounds like you need the transmission rebuilt

Posted on Sep 22, 2008

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My 97 gmc yukon 2 wd it started whining sound exactly like a power steering pump but only des it when put in gear and it bucks and slipps


Don't know if this will help, but we had a transmission shop flush ours & change a screen in it. Fixed it & was relatively cheap.

Apr 06, 2014 | 1997 Chevrolet K1500

1 Answer

700r4 transmission, my transmission is doing high rpm before shifting up from 1st gear, but with no slippage in any gear, rest of the upshifts are firm.BUT, on kickdown from 3 to 2.gear its going as i


I don't know if this will help,but i set my tranny up to shift hard like you are describing. Just by putting a clip on the kick down cable. The book talks about this, its cool if you like that sort of thing?

Jan 29, 2014 | Cars & Trucks

1 Answer

1995 Nissan Altima Stuck in First Gear


1. check transmission fluid level or if you can change the fluid & filter.
2. check throttle position sensor (tps).
3. if fluid level & tps are ok & still not upshifting automatically, temporarily (so you can take it to a transmission specialist) , try to manually shift. starting from dead stop, shift to D1. at about 25mph shift to D2. (be gentle on the accelerator & don't over rev on each gear. release accelerator pedal & don't step on the brakes while shifting from D1 & D2).

Apr 08, 2013 | 1995 Nissan Altima

1 Answer

It seems to be getting stuck in gear. The rpm will go up but it wont downshift. The fluid is fine, nice and pink, not burnt at all!!! I was told I cannot hook it to the computer at the car shop because the...


They are right, in 1995 the transmission ran by a computer for upshifts. But the ecm does control 4th gear. So it won't upshift? It stays in a lower gear? What gear does it hold? Sounds like a governor problem or a valve body issue.

Sep 23, 2010 | 1995 Jeep Grand Cherokee

2 Answers

Transmission will not shift out of 1st gear ,transmission will go into reverse and drive but will not shift out of 1st gear


Did you scan for codes? If there are codes pull them out
provide me with them and I'll try to diagnosis this. This could be anything. The shifter may be defective the transmission range sensor aka manual shift valve may be defective. When your in first is it slipping?

Mar 18, 2010 | 2004 Saturn VUE

2 Answers

Slips out of 1st and 5th


Have you checked your transmission fluid level and your transmission filter? That's a common cause of slippping.

Sep 27, 2009 | 1996 Toyota Tacoma

3 Answers

My 1989 Jeep with AW4 transmission does not downshift or ?


This model has a tranny computor under the dash on the right side screwed to the bottom of the dash. If I remember correctly, there is also an inline fuse attached to the harness. Check the fuse.

Feb 12, 2009 | 1989 Jeep Cherokee

1 Answer

Transmission trouble


Transmission model is a 4R70W,totally electronic,no vacuum to the trans.A common failure on that transmission is the 1-2 accumulator springs...they break,causing a harsh 1-2 upshift.An accumulator is a mechanical/hydraulic assembly also called an accumulator piston.It is made from steel with rubber lip seals bonded to the steel.The accumulator piston takes a certain portion of the hydraiulic fluid produced when the 1-2 upshift happens,and strokes up and down with springs providing resistance.It acts as a hydraulic shock absorber for the 1-2 upshift,providing cushion.When the springs break,it no longer provides shock absorption,hence the harsh upshift.It is located just inside the trans pan,on the passenger side front of the case.It is retained in the case with a cover and a round snap ring about 2" in diameter.A new piston and springs can be purchased from a transmission repair shop,or better yet,have them check the assembly for broken springs.Good luck

Sep 04, 2008 | 1999 Ford Crown Victoria

2 Answers

HYUNDIA 1997 ELENTRA 1.8


http://www.2carpros.com/how_to/transmission_service_4.htm
Popular Problems Checks
1. Car will not go into gear:
  • Gear selector cable has failed
  • Brake lock solenoid has failed not allowing the gear selector to move out of "Park"
  • Excessively low transmission fluid (note: if car is operated for an extended amount of time with low fluid level the transmission will fail prematurely)
  • Shorted electrical component not allowing the PCM to control the transmission. Example: shorted fuse
  • Flex plate (flywheel) is broken completely not transferring engine power to the transmission.
2. Car goes into gear but then fades out of gear or is slipping while driving:
  • Transmission fluid is low
  • Transmission clutch discs or bands are worn out or burned
  • Faulty transmission shift solenoid.
3. Car goes into gear but does not shift out of first:
  • Blown fuse to the PCM controller
  • Faulty vehicle speed sensor (VSS)
  • Shorted second gear control solenoid
  • Faulty transmission controller (PCM)
Tips About Common Problems and Fixes

Jun 21, 2008 | 1997 Hyundai Elantra

Not finding what you are looking for?
1990 Oldsmobile Cutlass Ciera Logo

Related Topics:

86 people viewed this question

Ask a Question

Usually answered in minutes!

Top Oldsmobile Experts

yadayada
yadayada

Level 3 Expert

63990 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21990 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you an Oldsmobile Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...