Question about 1997 Dodge Neon

1 Answer

My 1997 dodge neon is giving me a code 11

I have a 1997 dodge neon 2.0 sohc 5 speed. the code 11 is as i have seen it camsensor, crank position sensor or timing. i have changed both sensors along with both the o2 sensors and checked the timing is it is perfect yet i reset the system and i still and getting the code as well as lacking power. i also have changed all plugs and wires with bosch plugs and bosch wires. the code 11 came up and then when i got it rechecked i also had a code that meant the car was running rich in bank 0 i only have on bank ofcourse. i am pulling my hair out trying to figure out what it could be. i tried the pcm and the coil pack still no difference. please let me know if you have had any luck in what can fix it. emmisions is coming up and i dont stand a chance. my email is roughdog_91@yahoo.com i will check here often hope i can get some help.

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 405 Answers

If you can follow directions and understand service manuals I can tell you where to get all the troubleshooting and factory service guides. It, cost 20 bucks but it is well worth it, it will pat for itself with this one repair, and you still have access for a year, I use this site almost daily. www.alldatadiy.com, Its worth it.

Posted on Dec 27, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

My 2001 dodge neon cranked without the cam sensor connected. what's wrong with this picture?


Changing the Cam Position Sensor on Dodge Neon ...

? 10:33
https://www.youtube.com/watch?v=ciCPQ0kVAQY
Dec 21, 2012 - Uploaded by VeeTheAmazingGreek
... had to change out the cam position sensor on my 2001 Dodge Neon. ... 1997 Dodge Neon no start, crank sensor problems - Duration: 26:53.

Dodge Neon Questions - It will turn over but has no spark ...

www.cargurus.com > Questions > Dodge > Neon

CarGurusAug 9, 2015 - I did have a neon while ago and image crank sensor was bad ... my 1999dodge neon has no spark it will turn over but not fire i have changed the crank sensorcoil ... I have a 2001 Dodge Neon 2.0 with 140,000 kms on it.

Dodge Neon Questions - 2001 Dodge Neon will turn over ...

www.cargurus.com > Questions > Dodge > Neon

CarGurusJan 7, 2013 - I have a 2001 Dodge Neon 2.0 with 140000 kms o... ... went about a month before this recent problem, fixed that with no problem now this. ... firing. you said you replaced the cam sensor, did you do the crank sensor as well? ... My 1996Dodge Neon won't stay running whenever I take my foot off of the gas.

Starting Issues and Trouble Code Due to Defective Cam ...

repairpal.com > Problems > Dodge > Neon

Feb 05, 2016 | 2001 Dodge Neon

2 Answers

My 1995 dodge caravan trys to start but wont im getting no spark to my spark plugs


Hi mate start at the easiest point which will be to check your EARTH to make sure everything is earthed.

Feb 06, 2015 | Dodge Cars & Trucks

2 Answers

Code 11. what do i check?


11 camshaft signal or ignition signal, no reference signal during cranking
If you replace the CKP sensor (crankshaft position) you will more than likely cure the problem, I'll assume you have an intermittent engine stall out or hard not start?

Nov 03, 2011 | 1995 Dodge Neon

1 Answer

95 dodge neon trouble code 11 what sensor or ecu # is that


On your 95 Neon, the code 11 is for a problem with the crankshaft position sensor. The crankshaft position sensor mounts to the engine block behind the generator, just above the oil filter.

Oct 10, 2010 | Dodge Neon Cars & Trucks

1 Answer

I have 1997 neon 2.0 sohc how do if i know if the crank sensor is going bad or is just a fuel pump


Spray wd40 down the air intake while cranking the car if it fires off and tries to start
it is most likely at least partially the fuel - pump and or filter [s]

May 22, 2010 | 1997 Dodge Neon

1 Answer

I have a 2001 dodge neon that has this code obd11 what is it


code 11 means intermittent loss of either camshaft or crankshaft position sensor. check connections to both sensors. also look for any damage to the wires connected to each sensor. either sensor will set off a signal to pcm of a no crank referance signal detected during engine cranking.

May 01, 2010 | 2001 Dodge Neon

1 Answer

I have 5 trouble codes on my 89 dodge spirit they are 15 22 24 37 and 51


dont know what motor you have so here's all the possible engines

2.5L SOHC
15 .... Vechicle speed distance sensor
22 .... Coolant Temperture sensor ciruit
24 .... Throttle Position Sensor
37 .... Part Throttle unlock Solonoid Circuit
51 .... Oxygen feedback system stuck at lean position

2.5L SOHC Turbo
15 ... Vehicle Speed Sensor
22 ... Engine Coolant Temperture Sensor
24 ... Throttle Position Sensor
37 ... Baro Read Solonoid
51 .... Oxygen Feedback System

3.0L SOHC
15 .... Vehicle Speed Sensor
22 .... Coolant Temperture Sensor Circuit
24 .... Throttle Position Sensor
37 .... Part Throttle unlock Solonoid
51 .... Lean Condition is indicated

Feb 07, 2010 | 1989 Dodge Spirit

2 Answers

97 dodge neon died replaced parts and still no spark HELP.


YOU NEED TO CHECK DARK GREEN/ORANGE WIRE AT IGNITION COIL WHEN CRANKING ENGINE FOR POWER..IF NO POWER,SHUTDOWN RELAY IS NOT BEING ENERGIZED..THIS ENGINE ALSO HAS CAMSHAFT POSITION SENSOR ON END OF CYLINDER HEAD..ENGINE CONTROLLER NEEDS CAM AND CRANK SIGNALS TO ENERGIZE THE SHUTDOWN RELAY..UNPLUG CRANK SENSOR AND CHECK VOLTAGE ON ORANGE WIRE..SHOULD HAVE APPROX 8V..IF NOT..UNPLUG CAM SENSOR AND SEE IF 8V SUPPLY RETURNS..IF NO POWER TRY UNPLUGGING VEHICLE SPEED SENSOR LOCATED IN TRANS HOUSING WHERE RIGHT SIDE AXLE COMES OUT OF TRANS..IF 8V RETURNS..THE SPEED SENSOR IS SHORTED INTERNALLY..THESE 3 SENSORS SHARE THE SAME 8V SUPPLY CIRCUIT..WITH SPEED SENSOR UNPLUGGED,PLUG CRANK SENSOR BACK IN AND TRY TO START ENGINE..HAVE SEEN THIS SAME PROBLEM AT WORK RECENTLY

Jul 18, 2009 | 1997 Dodge Neon

1 Answer

99 Neon sohc keeps wipping the cam and crank sensors


Shake or gentle tug on the wiring harness and try starting the engine! I found that my problem was with the cam sensor wiring harness

Oct 07, 2008 | 1999 Dodge Neon

2 Answers

Instructions on how to change timing belt on a 1997 dodge neon sohc


motor vehicle technician for this job,not a weekend mechanic job

Jul 01, 2008 | 1997 Dodge Neon

Not finding what you are looking for?
1997 Dodge Neon Logo

194 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

60541 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21927 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...