Question about 2006 Chrysler PT Cruiser

1 Answer

WON'T START MY PT cruiser won't start. At first when I turned the key nothing happened. It is a 5 speed and I had the clutch in of course. Now the lights come on inside but it will not turn over. I drove it this a.m. approx. 2 miles and it started fine. I went out about 40 min. later and it would not start

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

My 2006 pt cruiser won"t start. the light do come on but it will not turn over just a clicking sound. i drove it for about an hour then went back to it 30 mins later and it didn"t start. just clicking sound.

Posted on Oct 21, 2008

1 Suggested Answer

SOURCE: 01 pt cruiser

take it to the dealer and tell the to replace the trans computer. to will cost about $350.00. i had to replace that part also at about 126000 miles...

Posted on Sep 09, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have 2002 pt . I have no problem with it, started it and put in gear, went to pull out and it shut off, now it won,t start back up, put new battery in, new switch, still nothing,


Possible starter failure if the engine doesn't crank. You can try tapping on the starter motor using a blunt object while turning the key to see if it starts. If it starts, suspect a defective starter motor. If it is a manual transmission, you can push start it in gear

Nov 21, 2015 | 2002 Chrysler PT Cruiser

1 Answer

2001 pt cruiser 5 speed, Turn key, no start, no noise... nothing... starter crank when jumping starter itself... jus cranks... no start still...


sounds like the solenoid had gone out. Also known as "starter relay". Mounted on top of the starter.

May 15, 2015 | Cars & Trucks

1 Answer

My 2003 PT CRuiser turns over to start but won't


I would start by checking fuel pressure with a gauge, and scanning the computer for trouble codes.
Low fuel pressure or a problem with the pump could cause the issue, as well as sensors such as the throttle position or engine temp sensor.

Sep 25, 2012 | Cars & Trucks

1 Answer

My pt cruiser Chrysler gearbox won't move from


is this a manual or a auto version ,if a auto then post question to a american expert ,only manuals here in spain

May 10, 2012 | 2005 Chrysler PT Cruiser

1 Answer

2005 pt cruiser won't start won't crank, everything works


When you turn the key on the ASD relay should turn on the fuel pump and power the injector, Do this lets cheat the system go to the ASD rely open the cover expose the inside have some one turn the key on does the ASD make contact? If not turn the key on collpase the ASD so it make contact do you hear the fuel pump come on? Now try this just as how you iopen the ASD do the same to the starter relay. Put the car in gear e brake on someone in the vehicle in case the car start and you are in front of it and it runs you over so at least they step on the brakes. Key on ASD exposed as your collapse the starter relay does the ASD relay turn on? Here why if you can control all the relay from under the hood you will need a ignition switch (the eletrical part)

Feb 22, 2012 | 2005 Chrysler PT Cruiser

1 Answer

2002 pt cruiser. Just replace the battery a week ago and the cables, the car runs fine with the battery disconnected so it cant be the alternator. when you put the key in and turn it on without starting...


jonboy;
I had the same problem. Check the wire in the terminal on the starter. That terminal is not crimped well enough around the wire.
It is pretty hard to get to, but removing the air cleaner and battery helps. When the PT won't start, have someone get ready to turn the ignition switch to start, reach down the left side of the battery (facing it) And give those 2 red wires (about the size of a lead pencil) hard yank just after your helper turns to start. You'll pull them out of a snap in wire holder, (which you can put back later when it is repaired). This should put the wire to the starter in a bind thus letting it start. You may see some sparks as the contact is made, or if loose enough, pull the wire out of the terminal. If this happens, you found the problem. Hope this solves your problem.
mikeselectric

Sep 23, 2011 | 2002 Chrysler PT Cruiser

1 Answer

I have a 2002 pt cruiser touring. I was driving and the oil light came on and then the car slowed down and died on me. It won't start and it sunds like it wonts to but it won't and the oil light...


Don't try start the engine when the oil light turn on, it would harm your piston, camshaft and crankshaft
It should be the oil pump has broken and need to replace, tow your car to the nearest service center

Jun 28, 2011 | 2002 Chrysler PT Cruiser

1 Answer

Hi! I have a PT Cruiser 2006. The car stood still for 5 weeks and when I was trying to start it, a light it the dashboard kept on flashing (electric sign). When I turn the key the starter cranks but it...


It is possible that you have a weak battery. You may want to try to jump the car with another car that is idling. If you get the car started then it is a weak battery. If not inspect the wiring especially for the ignition and the high tension wires.

Jun 21, 2011 | 2006 Chrysler PT Cruiser

2 Answers

My 2006 pt cruiser wont start, no lights or radio. nothing? when i turn key nothing happens inside or out


Check the battery terminals for corossion. Look for the chalky white powder which is a tell tale sign. Simply move the cable connectors back and forth a few times to loosen corossion and provide a better contact. Have you checked your fuses. I probably spelled corossion wrong, sorry.

Apr 25, 2010 | 2002 Chrysler PT Cruiser

Not finding what you are looking for?
2006 Chrysler PT Cruiser Logo

Related Topics:

1,208 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

60769 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

chargerhp
chargerhp

Level 3 Expert

813 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...