Question about 2004 Nissan Altima

1 Answer

My car run for a few minutes, and it stops. I think it is a sensor of som sort, but for me to find out i have to buy a scanner.

Posted by on


1 Answer

  • Level 1:

    An expert who has achieved level 1.


    An expert that hasĀ over 10 points.


    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 2 Answers

Go to any part store and ask them to run a diagnostic test on your car. Its free & it will tell you which sensors are bad. Good luck!

Posted on Oct 02, 2008


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

95 golf runs good on cold motor but after a few minutes it stumbles at low rpm excelleration

VW have 2 temp. for computer and one for radiator fan
you need scanner to check the temp.also vw is very bad with vacuum hoses braking.oil deep stick is part of the vacuum system.broken deep stick tube will cost the same symptoms.

Mar 25, 2014 | 1995 Volkswagen Golf

1 Answer

Corsa 55 stopped working

you NEED TO RUN THE scanner/computer Do not waste TIME+ MONEY the electronic vehicle is very complicated now in the vehicle. see the diagram attached.
You can have som faulty PCM+ignition COIL+BCM,sensor etc.
God bless you82f0eb87-7826-41b9-b872-68370982af06.jpg

Jul 17, 2013 | Cars & Trucks

1 Answer

1989 S-10 started running rough, now it's not running at all.

WOW ! believe it or not you did good ! what else could it be ? does this engine have a MAS, mass air flow sensor ? sell your scanner or take it back for refund, buy a new MAS, if your engine has one, and replace your air cleaner if you haven't. this part is a major player, if you have one, make sure its an OEM replacement part, not after market ! have you checked all your VACUUM LINES, is this an automatic ? anther thing, now that I'm thinking, what kind of COIL do you have ? I would suspect your coil and all that relates to the coil ! DO THIS FIRST ! before anything else. then more on, but I have a idea that this is it, go for it, when coils get too hot they tend to go bad, how are your spark plug wires ?

Mar 03, 2013 | Chevrolet S 10 Cars & Trucks

2 Answers

How do you reset computer after removing battery, or after charging battery after it has been dead

When you restart the car, the ecm will read sensors and reset itself to adapt to inputs it receives. Let the car idle for a few minutes, no gas petal at all, then drive it gently for a few minutes-then drive it normally. Because is has adaptive memory it will adjust for your driving techniques, and within 40 or 50 miles it will be completely set.

Mar 16, 2011 | 2004 GMC Sierra Denali

1 Answer

Wont start sometimes idles rough when first start, cut off

Do you check for codes every time you have a problem?
You know it isn't temperature related.
You know that pressing the gas pedal won't change computer input under certain conditions
How do you know you have fuel pressure? Do you drive with a gauge taped to the windshield?
Why didn't the shop repair it?
I would get a wiring diagram and check all grounds
Then scan the Throttle Position Sensor. As in, put a scanner or oscilloscope or volt meter on it.
Go through the entire system until you resolve it

Mar 18, 2010 | 1996 Buick Century

6 Answers

'92 cutlass ciera was running. Turned off for 5 min. then try to restart and won't. checked fuel delivery seems ok for now so what next

Check \out you ground and positive connections to the battery, altenator, & starter. Moister this time of year will cause corrosion between connections causing this nunsiance

Jan 23, 2010 | 1992 Oldsmobile Cutlass Ciera

1 Answer

My odometer works and stops

okey,like some cars they got cabel thats operates the odometer and som sensor.i think on the car sensor has gone,its on transmission on firewall side of the transmission

Oct 10, 2009 | 1998 Toyota Camry

1 Answer

2002 malibu wont start

check for a bad crank sensor for this controls the timing of crank shaft. and sends info to pcm. it will cause no spark or pulse at injectors.the engine may start but cut out in a few minutes or seconds, of operation. have the car scanned for the problem code, if no scanner, any auto parts store will scan for free. good luck !!

Sep 19, 2009 | 2002 Chevrolet Malibu

1 Answer

O2 sensor

1. first you need to re-set your computer. Try disconnecting the Negative battery cable for 5 minutes. If that does not reset itself, then you must go to someone with a scanner/engine analyzer & have it reset by them. Then after running it for a little while (few minutes or a few blocks) it needs to be rescanned for new trouble codes in order to see what all you did or did not get fixed to start with.
Note: .... there are LOTS of auto suppliers who will scan it for free if you buy your parts for them and or some of them will loan you the scanner to test it yourself (on their lot-location).

Jul 30, 2009 | 1997 Chevrolet K1500

Not finding what you are looking for?
2004 Nissan Altima Logo

Related Topics:

27 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts


Level 3 Expert

77932 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

726 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides