Question about 1991 Honda Civic

1 Answer

Slight miss (pull, ****) at full throttle at cruise (20-30 mph)

1) On decline, car barely started, then died) 2) Put 1 gallon of gas in (I had three in the tank), and the car started 3) This led me to believe there was dirt in the tank. 4) I changed the fuel filter and put gas and injector clener in tank 5) Car runs good, but still has the same pull-**** intermittently when I full throttle at low speed. Could the fuel pump be weak, and should the fuel pressure be tested. Thanks. Paul

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Sergeant:

    An expert that has over 500 points.

  • Expert
  • 350 Answers

Hi before spending your money get the fuel pressure tested then at least you know where your up to it expensive guessing yates210456

Posted on Oct 12, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to get Drive cycle



1. The testing has to start with the vehicle under 122 degrees F. Start the engine and idle for 2.5 minutes in Drive (auto) Neutral (MAN) A/C and rear defogger ON.

2. A/C OFF, accelerate to 55 MPH at 1/2 throttle and then 3 minutes of steady state cruise at 55 MPH.

3. Clutch engaged (MAN) no braking decelerate to 20 MPH.

4. Accelerate to 55-60 MPH at 3/4 throttle and 5 minutes of steady state cruise at 55-60 MPH.

5. Decelerate, no braking to end the drive cycle.

In some cases the Powertrain Control Module (PCM) will go into a logic lock not letting the readiness monitors run. Removing the battery cables and touching the two together will normally take care of the logic lock condition.

Apr 26, 2014 | 1999 Buick Park Avenue

1 Answer

Gas pedal wont go down once in gear


I would check a few things. first the engine mounts. make sure the engine isn't rocking over. second cruise control ? if it has cruise control I would unhook the cable to the throttle from the cruise control and see if that was the issue. some times the control box will pull in deceleration mode and stick there. also the decelerator valve on the throttle body may be defective.

May 24, 2013 | 1998 Dodge Neon

1 Answer

Drive cycle


Here is the OBD2 emission system drive cycle test procedure.
Engine coolant temp must be below 70c (158f) before starting the engine for either the first or second trip
The fuel level should be less than 1/2 full
First trip:
Start engine, idle for at least 1.5 minutes
Drive 3 minutes, hold b/f schdl: 1.5-2.0 msec, selector lever "3rd" eng rpm 1,800-2,000 A/C switch:ON Hold the recommended b/f schdl range. Allow road speed to vary as necessary.
Drive at 55-65 mph for 1.5 min b/f schdl 2.0-3.2 msec, selector lever "5th" Engine rpm 2,200-3,000
IGN "off" for at least 10 seconds (not more than 5 min)
Dive at 50-60 mph for 3 minutes Selector lever "4th" keep engine speed above 3,000 rpm Allow speed to vary if necessary. Do not decelerate for more than 3 consecutive seconds. A/C switch ON.
Drive at a steady state cruise of 53-58mhp b/f schdl more than 1.8 msec selector lever "5th" eng rpm 2,400-2,600
Downshift to "4th" and decel more than 5 seconds without breaking, then idle for 1 minute.
Drive two minutes b/f schdl less than 2.0 msec Accelerate to 41 mph, decelerate to 34 mph, accelerate to 41mph. Do not completely release the accelerator. A/C switch off.
Idle 1 minute in park or neutral
Drive two minutes Steady state cruise at 31-44 mph. Selector lever "4th" A/C switch OFF. Hold the accelerator pedal as steady as possible. Allow speed to change if necessary.
End of first trip. Turn the key off the begin the second trip.
Second trip:
Start engine, idle for at least 1.5 minutes
Drive 3 minutes, hold b/f schdl: 1.5-2.0 msec, selector lever "3rd" eng rpm 1,800-2,000 A/C switch:ON Hold the recommended b/f schdl range. Allow road speed to vary as necessary.
Drive at 55-65 mph for 1.5 min b/f schdl 2.0-3.2 msec, selector lever "5th" Engine rpm 2,200-3,000
IGN "off" add four gallons of fuel
Dive at 50-60 mph for 3 minutes Selector lever "4th" keep engine speed above 3,000 rpm Allow speed to vary if necessary. Do not decelerate for more than 3 consecutive seconds. A/C switch ON.
Drive at a steady state cruise of 53-58mhp b/f schdl more than 1.8 msec selector lever "5th" eng rpm 2,400-2,600
Downshift to "4th" and decel more than 5 seconds without breaking, then idle for 1 minute.
Drive two minutes b/f schdl less than 2.0 msec Accelerate to 41 mph, decelerate to 34 mph, accelerate to 41mph. Do not completely release the accelerator. A/C switch off.
Idle 1 minute in park or neutral
Drive two minutes Steady state cruise at 31-44 mph. Selector lever "4th" A/C switch OFF. Hold the accelerator pedal as steady as possible. Allow speed to change if necessary. I especially like the part where they want you to add four gallons of fuel. Not three gallons, not five gallons, four gallons. Gotta love those Nissan engineers. ...and of course they state that if the trace is not followed exactly (i.e. you botch the acceleration/deceleration) you have to start all over again from scratch

Feb 09, 2012 | 1996 Nissan Pickup

1 Answer

In Cold weather my 2001 Chevy Cavalier died frequently?


Check the throttle linkage at the throttle body look for anything that could be binding the linkage up and preventing the throttle from closing, (ie something getting caught in there) if thats ok, the cable could be starting to fray inside it's sheath and binding up the throttle as well or could be kinked. if thats the case, a new throttle cable is needed. Also besure that the cruise wasnt on and you didnt engage the cruise by accident.

May 30, 2009 | 2003 Chevrolet Cavalier

1 Answer

1996 Seville died and won't start


Try Spraying Some Throttle plate cleaner into the throttle bore & see if it tries to start?? If Yes Most likely fuel pump died.

May 08, 2009 | 1996 Cadillac Seville CA Value

1 Answer

Mass air and throttle position


sounds to me like your having a air leak... my hose on my tahoe had a tiny pin leak in it and it did the same thing... check the small hose that goes from the air filter to the head of the motor... that was where mine was if not, check your o2 censor...

Jul 04, 2008 | 1999 Chevrolet Tahoe

3 Answers

99 tahoe dies starts dies


sounds like a throttle position sensor. or perhaps a mass air flow sensor. let me kkow MrRodneyLong@gmail.com

Jul 04, 2008 | 1999 Chevrolet Tahoe

Not finding what you are looking for?
1991 Honda Civic Logo

Related Topics:

128 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

yadayada
yadayada

Level 3 Expert

60541 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21927 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...