Have you tried taking off the cover to see if the indicator cover is part of the entire wing mirror cover. I think it might all be part of the same cover. The Haynes manual may be able to help more.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Do you mean the turn indicator located in the mirror assembly? There is no way to replace that other than to replace the entire mirror assembly. I would be checking the wiring harness to the door before replacing the mirror. There could be a broken wire in the umbilical that goes between the body and the door.
It's been a while, you go through the glass.. the big glass.. grab it lightly
slide it up adn then over left.. the bottom glass.. slide it left and the up and right at the same time.. its a little touchy so be patient.. now i cant remember but i think you have to removed the motor.. then you can access the bulb behind it.. best of luck!!
FIRST U MUST REMOVE THE MIRROR.BE CAREFULL THEY TEND TO CRACK.THEN UNBOLT THE 2 TORX N8 .NO 8 AT THE ILLUSTRATION.REMOVE THE COVER GENTLY UPWARDS.UNCLIP THE INDICATOR PLUG WITH THE COVER OUT U MUST SEE ONE MORE TORX NO8 UNBOLT AND REPLACE THE INDICATOR.REPEAT THE PROCEDURE BACKWARDS TO ASSEMBLE THE MIRROR.CLICK IF U FIND THIS HELPULL.LET ME KNOW IF U NEED MORE INFO...GOOD LUCK!!
I changed mine a few years ago (2005 Sharan). Price of the LED part was ~£20 from the main dealer. Biggest problem was taking the mirror unit apart. I spent ages removing the mirror then seperating the parts. Later some ne'r-do-well knocked into the mirror on a bike, folding it towards the front of the car, and it all just came apart in such a way as to make changing the indicator easy!
Ok very carefully pull off the mirrior blade. The mirrior blade is clipped but EXTEMELY fragile and will break if forced. From there remove the 2 heated blade wires. The cover is also clipped as you will notice after that is removed. You have to pry with a plastic tip between the cover and hosing near the body of the car while pulling the clips in the housing you see to lift the cover straight up. Once this is done you'll need a t-10 torx screwdriver to remove the lower portion. These screws are when you're looking straight down. With this assembly off you can access the 2 other little screws holding the flasher to the bottom cover. Remove the wires and the little clip and there you go. Installation is reverse.