I have a 2006 Hyundia sonata it is over heating and when it get to hot it wont start i cant even drive around the block with out it over heating

Changing the brake pads on a vehicle with calipers if very easy in comparison to drum brake. You, unless you have the strength will need a tool to compress the caliper piston to make room for the new pads to fit over the caliper. After that it is a matter of two bolts to put the caliper back on and bleed the brakes.

trans oil temp sensor will make this trans act up and a possible tcm update may be available for these cars

Mine did the same, replace kickdown servo. if not the problem, replace tranny.

It's located forward of the RH front wheel behind the wheel well liner.

Lots of bulbs in a car. Which one you looking to price?

go to http://www.onlinemechanical.net/serpentine-belt-diagrams.html you'll find the hyundia sonata diagram about halfway down the page

right below the exhaust manifold on thr right hand side of motor

There was recall for the 2006 and 2007 Hyundai Sonata Brake Light Switch assembly. www.promanuals.net

factory immobiliser has cut in .NO YOU CANT BYPASS IT ,well not very easily

ON MY HYUNDIA, IF YOU OPEN THE TRUNK AND LOOK UNDER THE LIGHT, YOU WILL SEE 2 NUTS THAT ARE RECESSED UP UNDER THE LIGHT. THAT MIGHT HELP.