Question about Chevrolet Blazer

2 Answers

GOVERNOR GEAR DO YOU HAVE TO DROP THE TRANSMISSION TO PUT A NEW GOVERNOR GEAR IN A 1988 NISSAN SENTRA?

Posted by on

  • TIDELINE1200 Sep 21, 2008

    thanks emissionwiz, but what do you do? it says that there is a roll pin holding it! it is not like most models. it is on topside of trans! took the four bolts out that hold the govenor! but the gear is still intact in place tried to lift ,pull etc!!! wont budge any tips greatly helpful thanks, again!

  • TIDELINE1200 Sep 21, 2008

    does any one have any pics on how to remove the govenor gear on 1988 nissan sentra 1.6,a/t?

×

2 Answers

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 2 Answers

It is hold in place by a 10mm bolt just below the governor's cover cap.

Posted on Apr 04, 2010

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • Chevrolet Master
  • 63,801 Answers

No,

Posted on Sep 21, 2008

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

93 sentra will not shift out of 1st gear


Is it a automatic or manual transmission Alex?

Jan 15, 2013 | 1993 Nissan Sentra 4 Door

1 Answer

Trying to figure out where to put transmission fluid for a 1992 nissan sentra xe.manual transmission


Well...

U have to get ur car to a LiFTER and unscrew the PLUG on the side of the transmission and u could fill the lubricant in that hole.

Opening that plug at the bottom of the transmission means ur going to drain the old lubricant and have to put a NEW gear oil!

At the age of that Nissan, it really needs a GOOD new slicky fluid! additive to go w/ it is GREAT!


Hope the slips everything up!

Dec 03, 2010 | 1992 Nissan Sentra 4 Door

1 Answer

Trans wont shift out of first gear


governor or throttle valves are stuck

Jul 06, 2010 | 1993 Nissan Sentra 4 Door

1 Answer

Nissan pulsar 1988 wont go into gear I can put the gear stick in the right gear but does nothing wont reverse or drive, its automatic and has a reconditioned engine in it


try checking your transmission oil (i had the same problem but after $30 it was fixed) it might had drained out. if your transmission oil is fine then consult a mechanic preferebly an automatic transmission specialist. may be your transmission needs a rebuild.

May 20, 2009 | 1988 Nissan Pulsar

2 Answers

Transmission


Often when you have problems with shifting, you have worn out your fluid and all the internals of the transmission, (clutches and friction plates,)will wear out on the old burnt fluid. When you replace the fluid, and or filter, you often make the situation worse because the new fluid has nothing to grab onto. The clutches and plates inside your trans are worn out.

So yes, It is time that you get a new/used/rebuilt trans

May 14, 2009 | 1993 Nissan Sentra 4 Door

3 Answers

Geo TRacker aut trans doesn't shift from 1st


100 parts in a tranny.
bad governor unit in tail shaft.
low oil pressure.

see my tranny page.
http://carfix.stufftoread.com/


Feb 02, 2009 | 1993 Nissan Sentra 4 Door

3 Answers

Nissan sentra 1997 starts but wont go when put in gear


is it a manual or automatic?if it's manual check clutch.if it is automatic check transmission fluid.

Dec 02, 2008 | 1997 Nissan Sentra

7 Answers

My transmission wont shift out of first gear


Hi, I hope this will help you , there is a part call the governor ,is on top of your transmision ,and looks like a distribuitor,,this have a plastic gear at the end of the shaft that wear out and dont let the transmition to shift ,,it have a ten mm bolt that holds it in place ,,,is a comon problem of nissan..... good luck.....

Aug 26, 2008 | 1993 Nissan Sentra 4 Door

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

419 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

63661 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21981 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...