Question about 1996 Plymouth Neon

2 Answers


Posted by on

  • pat  murray
    pat murray May 11, 2010

    if it is turning over i would check and see if cam is turning may be a timing belt problem

  • Cnythia Miller May 11, 2010

    You check,

    Is starter or batterry good?



2 Answers

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.


    An expert that has over 500 points.

  • Plymouth Expert
  • 293 Answers

I assume you have solved this issue

Posted on Oct 05, 2008

  • Level 1:

    An expert who has achieved level 1.


    An expert who has answered 20 questions.


    An expert that has over 10 points.


    An expert whose answer got voted for 2 times.

  • Contributor
  • 23 Answers

I agree it may have jumped time.

Posted on Oct 03, 2008


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Replacing starter. I got the two bolts out but why can't I get the wire bolts out?

Is the bolt just spinning not allowing the nut to come off? In that case remove the starter with the wire attached. Or cut the wire and replace it. Or cut off the nut with a cutoff wheel. If you have the 2 bolts off the starter should come off the car. Unless it has a hidden third bolt! Cut the damn wire if you have to. Don't forget to take off the little wire.

Oct 05, 2015 | 2001 Chevrolet Blazer

1 Answer

Car in park turn key starter engages engine starts and you can hear the Bendix still spinning in the ring gear put car into drive and then they stop spending

Does the starter engage again when you go back to park ?
Shifting from park to drive would cut the circuit from the key switch to the starter. The neutral safety switch prevents you from cranking the engine in drive or reverse.
I would say the key switch is not turning off power to the starter when you go from start to run.

Sep 14, 2015 | Cars & Trucks

1 Answer

I have a Acura rl 2005 and my a/c doesn't work and I want to know what's the problem.. My heat works but not the a/c.

You will proably need a diagnostic done by a professional because it takes special tools to test for refridgerant. A couple things you can look at . First with car off see if you can move center part of compressor if it spins good if not, compressor may be problem. Then remove low side shrader valve cover and depress valve quickly, does any gas come out,if so good now start car,turn on a/c does center of compressor spin or is it stopped. If not spinning may be low enough on charge that low pressure cut-out has engaged. If it spinning you may have a plugged expansion valve take it to apro

Apr 04, 2015 | 2005 Acura RL

1 Answer

My jcb jz140 cut out when spining around and now say flywheel code 108 an wont start what can i do?

If the engine is turning over(cranking but not starting) then theres a chance you damaged your crank sensor. When u say spinning around do you mean you were 360 wheeling at a high rate of speed, because you could also have picked up debris in the bell housing that damaged or is obstructing the signal form the flywheel to the crank. Check the sensor cable and connections first if the car is cranking.

Oct 09, 2014 | Cars & Trucks

1 Answer

Start power cut

try the idle control valve it could be starting to fail.

Jan 20, 2014 | Saab Cars & Trucks

1 Answer

I have a renault clio 1999 T Reg. The problem started yesterday when I was starting the car. It was starting but cutting out almost straight......its as if its an electrical cut out. As if its being told...

The car is spinning faster because the battery charged itself since it hasn't been drove. Check all your fuses first. Ignition fuses and fuel pump fuse. Make sure the fuel pump is kicking on. You should hear a buzzing sound when you first turn the key for a second or two. Put your head in the back seat. If it is not kicking on, this could be the problem. You can spray gas in the carborator to tell to. Start your car and see if it starts. If it starts, then dies, it is fuel related. Either pump, filter, injectors, fuel rail. Make sure your spark plug wires are all connected and in good shape. Check the timing belt. You can check this by removing the front protection cover. Make sure the belt is good and there is no teeth missing. Write me back when you check this or you have a question. I am here to help my friend in any way I can.

Feb 10, 2011 | Renault 181 Cars & Trucks

1 Answer

The car was running fine we drove it to the store no Problem with the Jaguar 1989 XJ6 the car was running fine we drove it to the grocery store and came out it would not start put gas in it and it...

Sounds like fuel pump is bad. Running fuel low puts alot of strain on electric fuel pumps. The fuel acts as a coolant for the pump, that's why it's advisable to keep at least 1/2 tank. It sounds like your pump finally just gave up. Pump might be making noise but it could just be spinning and not pumping. Have someone test your fuel pressure to confirm.

Jan 07, 2011 | 1989 Jaguar XJ6

1 Answer

Went to start car didn't leave key on long enought o start, tried again and all it did was make that humming noise. Is there a fuel shut off switch when car doesn't start the first time?

sounds like the starter is spinning but the solinoid is not pushing the drive in to flywheel, could be low battery, bad connection, try tapping on the starter while its being cranked, but be careful of moving parts cutoff should not normally cut in

Dec 06, 2009 | 2005 Hyundai Tucson

1 Answer

I was driving and my car stop runing what could be the problem

check timing belt! very common to go while driving. if not then spark and fuel is what would be next on the list. did it make any noise or warning before it cut of? and does it crank over and just not start? if so does it sound like it is spinning over fast that usual?

Oct 25, 2009 | 2000 Dodge Intrepid

Not finding what you are looking for?
1996 Plymouth Neon Logo

Related Topics:

59 people viewed this question

Ask a Question

Usually answered in minutes!

Top Plymouth Experts


Level 3 Expert

77499 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8826 Answers

Are you a Plymouth Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides