Question about 1991 Dodge Dynasty

1 Answer

Locked in L

VEHICLE IS LOCKED IN LOW. DRIVER PUT IN L AND TOOK KEY OUT VEHICLE LOCKED AND WILL NOT COME OUT AND WILL NOT START

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

You might try putting the key in and turning the wheel a little. While keeping the wheel turned with one hand, turn the key with the other back to the off position.

Posted on Oct 18, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

2000 pontiac montana security system locked and it won't start. The information center on the van shows as follows; Low battery light, Then Security light, Then Low fuel light. Its full of gas. Help?


Does the security light come on when you turn the key to run ,Does it go off in a few min. The proper way to reset the anti-theft system would be to turn the key to the on position for 10 min. if the light goes out in that time ,turn the key off for a few seconds . Then try an start the vehicle . If light comes back on an won't start there is a hard fault . You mite at that point wan't to do a theft system by- pass . Also have your battery checked and or charging system . A low battery , a malfuctioning charging system may cause these type problems .

Oct 27, 2016 | 2000 Pontiac Montana

1 Answer

My key will not turn in the ignition and the wheels are not locked


Auto Recall Date:AUG 06, 1998 Vehicle Component: POWER TRAIN:AUTOMATIC TRANSMISSION:PARK/NEUTRAL START SWITCH Estimated Vehicles Affected:685000 1998 Plymouth Breeze Defect Summary:VEHICLE DESCRIPTION: PASSENGER VEHICLES EQUIPPED WITH AUTOMATIC TRANSMISSIONS. THE ADJUSTMENT OF THE CABLE CONNECTING THE CONSOLE SHIFTER MECHANISM TO THE IGNITION KEY CAN CAUSE A TRAPPED KEY CONDITION WHICH CAN RESULT IN A LOW FORCE REQUIRED TO DEPRESS THE SHIFT BUTTON. A COMBINATION OF APPLYING A MIS-ADJUSTED RELEASE BUTTON WITH A LOW FORCE ATTEMPT TO SHIFT OUT OF PARK WITH THE KEY IN THE LOCKED POSITION, CAN BREAK THE Sounds Sounds like a recall to me: BTW Have you checked for any recalls? You have alot on this vehicle.CONNECTING PIN IN THE SHIFTER. Defect Consequence:IF THIS HAPPENS, THE "IGNITION-PARK" INTERLOCK SYSTEM WILL BE NONFUNCTIONAL. Remedy:DEALERS WILL INSPECT FOR PROPER OPERATION OF THE SYSTEM. ANY VEHICLES THAT ARE NOT FUNCTIONAL AFTER THE INSPECTION WILL HAVE THE SHIFT MECHANISM AND CABLE REPLACED WITH A "SELF-ADJUSTING" DESIGN. Notes:CHRYSLER CORPORATION

Sep 17, 2010 | 1998 Plymouth Breeze

1 Answer

My 1989 Acura Legend was locked in park this morning. After some looking at, I took a key and stuck it in the "automatic shift lock." This took it out of park and allowed me to drive to work, but if I take...


Your shift lock is wired to the brake light fuse when you start your car and put you foot on the brake you should hear a acturator clicking. It is connected to the shifter. check your fuse which is located driver side fender under the hood if bad replace fuse if acturator is bad Call Honda parts you can replace this your self might want a manuel for that. Good Luck

Jul 12, 2010 | 1989 Acura Legend

1 Answer

My mom, got inside the car. and when she was inside she accidentaly click the PANIC button ON, of course Click it again, so it would go off. But now, the car doesn´t start! and it was working...


from outside the car make sure all doors a closed completely, make sure hood and trunk are also closed. lock the vehicle with the remote, unlock it and repeat, lock and unlock. if it still wont start, put the key in the driver door lock, lock and unlock the door three times with the key, then try to start.

Oct 16, 2009 | 2003 Toyota Corolla

2 Answers

Key won't turn in 2002 Jeep Liberty, can't start. Battery seems fine (at least enough power for clock, dome lights, and power locks), and vehicle operated normally a few hours earlier. Key simply won't...


put the key in the ignition and tap the key farther into the cylinder and turn. should work. seems like a chrysler problem! a handy tow truck driver showed me this solution last night. you can have the cylinder replaced if this keeps happening or just keep a handy-dandy whacking object in your center console for just such an occassion!

Apr 24, 2009 | 2002 Jeep Liberty

1 Answer

2007 Lexus driver door will not lock.


Try using the button on the door. Remember you have a smart key so whenever you approach the vehicle and put your hand in the door handle it automatically unlocks the driver's door. To verify your vehicle is locked, lock your doors and walk away from the vehicle. Leave your key away from your vehicle and THEN approach it again. Your vehicle should still be locked. If it is opened, go to your local Lexus dealership. They will be able to correct the problem for you.

Mar 10, 2009 | 2007 Lexus ES 350

Not finding what you are looking for?
1991 Dodge Dynasty Logo

Related Topics:

56 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

60769 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...