Can you use a sl2 clutch kit for a saturn sl - 1996 Saturn SL

Here's your book info is below...
Most auto parts stores carry Haynes Manuals. You can order them from Haynes if needed. Or...often they are carried in your local library.

I have done Ford and Toyota clutches using these books. Clutch replacement is not hard, just time consuming...And easier if you have a lift.

Note: If like many vehicles, don't forget to replace the engine rear main seal while you have access with the fly wheel off.

You can call Haynes and ask specifically if the book covers the repair you are attempting. I have called them to get more specific wiring diagrams not always provided with the books. Very helpful in providing tech data... I have a Haynes manual for all my vehicles...makes maintenance and repair much easier than researching every I need to do something to my vehicles.

Best of luck finding the information you need...

Here's your book info.

Saturn S-series Haynes Repair Manual Online covering all 1991 thru 2002 models of Saturn SL, SL1, SL2, SC, SC1, SC2, SW1 and SW2
Part Number #E87010
Haynes Repair Manual Online for the Saturn S-series covering all 1991 thru 2002 models of Saturn SL, SL1, SL2, SC, SC1, SC2, SW1 and SW2 has clear instructions and hundreds of photographs to help you perform anything from simple maintenance to basic repairs. Whether you're a beginner or a pro, you can save big with Haynes!
Complete coverage for your 1991 thru 2002 Saturn S-series (SL, SL1, SL2, SC, SC1, SC2, SW1 or SW2):

--Routine Maintenance
--Tune-up procedures
--Engine repair
--Cooling and heating
--Air Conditioning
--Fuel and exhaust
--Emissions control
--Ignition
--Brakes
--Suspension and steering
--Electrical systems
--Wiring diagrams

There are 2 different engines for the 92 SL,they are 1992 Saturn SL 1.9L TBI SOHC 4cyl 1992 Saturn SL 1.9L MFI DOHC 4cyl Here's a link to the blower motor resister,it's located next to the blower motor,2 screws hold it on.

like a new clutch like when you bought it new has nothing to do with engine if the cluctch isn't right then job wasn't done right

You need to adjust the clutch cable. It runs from the fire wall to the shift lever on the back of the transmission.

Call around to local junkyards, any e-brake lever from a 96-99 SL or SW should work. There are also scavengers on ebay motors who will go out and get the part you need, saving you the trouble. Also folks selling old saturns, part by part, on your local craigslist.

they are hydraulic, there is no adjustment. you need a clutch replacement if it is slipping.

find the low pressure switch on the accumulator, if you jump the terminals, the refrigerent level is too low to turn the clutch on.

A/C compressor clutch relay maybe . It's located in the under hood fuse box . If you look on the bottom of the relay an see pin's 30 & 87 an locate where they plug into the fuse box an jump with a piece of wire . Just to see if clutch engages . Pin 30 should have B+ voltage .

Pivot of pedal srm needs Lubrication. Heat expands bushings and such. If it is the pedal return spring , lub the springs where they hook on each end.

several vendors selling on ebay.