P1763 - Governor Pressure Sensor Voltage Too High
This code is refer for the governor pressure sensor which is located in the valve body of the transmission. If getting power to the sensor and the wires are not open or shorted then the sensor will need to be replaced.
GOVERNOR SOLENOID AND PRESSURE SENSOR
REMOVAL
Hoist and support vehicle on safety stands.
Remove transmission fluid pan and filter.
Disengage wire connectors from pressure sensor and solenoid (see picture)
Remove screws holding pressure solenoid retainer to governor body.
Separate solenoid retainer from governor (see picture)
Pull solenoid from governor body
Pull pressure sensor from governor body.
Remove bolts holding governor body to valve body.
Separate governor body from valve body
Remove governor body gasket.
INSTALLATION
Before installing the pressure sensor and solenoid in the governor body, replace O-ring seals, clean the gasket surfaces and replace gasket.
Place gasket in position on back of governor body
Place governor body in position on valve body.
Install bolts to hold governor body to valve body.
Lubricate O-ring on pressure sensor with transmission fluid.
Align pressure sensor to bore in governor body.
Push pressure sensor into governor body.
Lubricate O-ring, on pressure solenoid, with transmission fluid.
Align pressure solenoid to bore in governor body
Push solenoid into governor body.
Place solenoid retainer in position on governor
Install screws to hold pressure solenoid retainer to governor body.
Engage wire connectors into pressure sensor and solenoid Install transmission fluid pan and (new) filter.
Lower vehicle and road test to verify repair.
1 - PRESSURE SOLENOID RETAINER
2 - GOVERNOR
1 - PRESSURE SENSOR
2 - PRESSURE SOLENOID
3 - GOVERNOR
Hope helps.
1,533 views
Usually answered in minutes!
×