Question about 2002 Jeep Grand Cherokee

2 Answers

Turn signal My 2002 jeep grand cherokee's turn signal works intermittently. The multifunction switch seems to fine with no loose connections. The hazard lights work without failure. Any suggestions?

Posted by on

  • 2 more comments 
  • Anonymous May 21, 2009

    I have the same problem.

  • emburkern136 May 11, 2010

    where do you find a flasher??

  • Anonymous Mar 15, 2014

    locating hazard fuse on 2002 jeep grand

  • Steve lock
    Steve lock Apr 27, 2015

    its the flasher it is on top of fuse box and a pain in the a@@ to change they cost around $70.00

×

2 Answers

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

  • Contributor
  • 2 Answers

Try a flasher

Posted on Sep 19, 2008

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 2 Answers

Take switch out and spray contacts with contact cleaner its a jeep thing

Posted on Jul 29, 2013

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Indicator lights


well there could be a couple of things happening here your flasher could be on it's way out, which is on your fuse panel, check your owners manual, or if there is a cover, for which one this is you could have a bad ground, which these our known for or a broken wire or loose wire the best way for someone to try to find this, is when this happens, take a test light or volt meter to back probe the wires to try to find the break in the wire, then trace your ground and make sure it has good contract, if rusted clean up check for cracks, bare spots in any of these wires, if found fix, by splicing wire, using a crimp wire connector, with a heat shrink tubing to protect it, these can be found at an auto parts store also your turn signal switch could be at fault here

Dec 05, 2013 | Jeep Grand Cherokee Cars & Trucks

3 Answers

I have a 2002 jeep grand cherokee and my turn signals stopped working. My hazard lights are working fine. Lights are working also. But im not getting a light on the dash for my turn signals.


I have the same issue. I took the flasher relay out, inspected the pieces for any hairline fractures on the circuit board, nothing it was clean. On my jeep, the turn signals always work in the Spring, Summer, Fall months, but as soon as Winter hits I loose my turn signals. Also, I know it is temperature related because I drive around for a half hour and the signals work again. It is really strange, I think the issue is somewhere in the ground wire, I will be checking that next and will post any new information. Anybody else who has had this issue and correlation I would certainly like to hear about any solutions. Thanks

May 03, 2012 | 2002 Jeep Grand Cherokee

1 Answer

Trun signals intermitently work, checked bulbs wires, fuses, i believe this problem is linked to the hazard lights. Is this posible? where is the hazard relay located?


yes it is linked with the hazard light in a way. when you turn the hazard light on do they seem like they work fine?? if they work good, i would say your need a turn signal flasher, of course the hazards run off of a flasher unit too.. they very from vehicle to vehicle, but most of the time they are under the dash on drivers side... turn your signal on and listen for the clicking, you should find it fairly quickly and easily, that is where your problem most likely is. hope this helps

Dec 07, 2010 | 2002 Jeep Grand Cherokee

2 Answers

Turn signals hazards flasher don't work jeep cherokee replaced combination flasher relay, turn signal switch and still no signals


I NEED TO LOCATE THE SWITCH WHERE IS IT ?
MY INDICATORS NOR HAZARD LIGHTS ARE WORKING I DONT KNOW WHAT IS WRONG WITH IT CHANGED BULBS BUT NOTHIGN THEY ALL WENT OUT AT THE SAME TIME
SO THERE MUST BE A RELAY SWITCH SOMEWHER BUT DONT KNOW WHERE ?
THANKS FOR HELPING

Sep 27, 2009 | 1999 Jeep Cherokee

1 Answer

Left directional light intermittent to plain out...


I was once a fleet manager with many Jeep Grand Cherokees 1999-2002. We had TREMENDOUS problem with REAR tailight housings. It seem the tailight/signal/back-up light circuitry is embedded in the plasticx of the housing. NO WAY to repair. Replaced with a new one from Jeep. Problem gone. ( at least until the other side went bad ) Not a guarranty, but it's a good chance it has the same problem.

Mar 31, 2009 | 2007 Jeep Grand Cherokee Overland

1 Answer

98 jeep grand cherokee's turn signal on the dash and the lights quit working...the hazard lights are fine.


Turn Signal Light and Hazard Lights have one separated accesory. For this component review the Page 8J-1 / Fig 2 in this document: ZJ-Secc-8J-Turn-Signals-and-Hazard-Warning-Flashes

Maybe can help you. Good luck.

Nov 09, 2008 | 1993 Jeep Grand Cherokee

Not finding what you are looking for?
2002 Jeep Grand Cherokee Logo

Related Topics:

819 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

64052 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21990 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...