Cars & Trucks Logo

Related Topics:

Posted on Sep 18, 2008
Answered by a Fixya Expert

Trustworthy Expert Solutions

At Fixya.com, our trusted experts are meticulously vetted and possess extensive experience in their respective fields. Backed by a community of knowledgeable professionals, our platform ensures that the solutions provided are thoroughly researched and validated.

View Our Top Experts

Wont start ,

Now if i put gas into carb it will start for a while then shut off i replaced the fuel filter ,but before finished i did that i cranked it and fuel came out of the line what could it be the trcuk was not driven for over a year

2 Answers

Anonymous

Level 1:

An expert who has achieved level 1.

Problem Solver:

An expert who has answered 5 questions.

  • Contributor 4 Answers
  • Posted on Jan 23, 2009
Anonymous
Contributor
Level 1:

An expert who has achieved level 1.

Problem Solver:

An expert who has answered 5 questions.

Joined: Jan 23, 2009
Answers
4
Questions
3
Helped
2825
Points
9

If you are getting gas from the fuel line the pump is working, but still may not have enough volume or pressure to start the truck. More than likely it will be the fuel pump.

Anonymous

Level 3:

An expert who has achieved level 3 by getting 1000 points

All-Star:

An expert that got 10 achievements.

MVP:

An expert that got 5 achievements.

Vice President:

An expert whose answer got voted for 100 times.

  • Master 360 Answers
  • Posted on Sep 18, 2008
Anonymous
Master
Level 3:

An expert who has achieved level 3 by getting 1000 points

All-Star:

An expert that got 10 achievements.

MVP:

An expert that got 5 achievements.

Vice President:

An expert whose answer got voted for 100 times.

Joined: Sep 17, 2008
Answers
360
Questions
1
Helped
214572
Points
1130

Fuel pump......... smack the gas tank while cranking should start check the fuel pump relay you can jump the two big prongs on this that is the fuel pump good luck

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

Crank no start spark ok gas in the carb ok i put fuel in the intake its start and run for 10sec

Is the fuel pump pumping gas to carb? Fuel filter cloged. Are floats on carb stuck not allowing suffecient fuel
0helpful
1answer

1976 bmw 2002 cranks but won't start

For a minute there I was going to say a 2001 would not have a carb.
If the fuel line has no gas, is the pump working ?
0helpful
1answer

1987 mercrusier 180hp wont stay running unless i pump the gas

Could be a small amount of rust got into fuel filter from sitting empty, try changing fuel filter before worrying about the fuel pump.Filters could be partly plugged and its always smart to start with the cheaper fixes first.
0helpful
1answer

I changed the fuel pump and fuel filter, im getting gas upto the injectors/carb, but only starts if i put gas in the carb, but then dies quickly wont get gas. any ideas?

If the tps (throttle position sensor) gives a high signal it will put the computer in clear flood mode which shuts off the fuel injector. Easy test, unplug the tps and try to start it. The tps is the 3 wire sensor at the end of the throttle plate If not suspect the ignition module under the distributor cap.
1helpful
1answer

Engine stalled out,would not start, pour gas in carb,cranks,keeps running,until idle falls below 12to1500rpm,than stalls out again and will not crank,repeat gas or starting fluid in carb,cranks runs and...

This truck is fuel injected, the problem sounds like a weak fuelpump, it runs when you pour gas into it until that gas runs out, the first thing is to test the fuel preasure, if the pump is weak it may run with gas poured into it but wont idle, also a common problem is the coolant temp sensor and the ground wires to thermostat housing bolt but i wont bet its the pump inside the fuel tank, if you put a fuel gauge on it there should be at least 55-61 psi if its a few pounds lower it can cause problems, you have everything else and it runs with gas poured so its a fuel problem check the preasure, theres a valve up top on the fuel line to connect a fuel gauge to it, start there hope this is helpful.
0helpful
1answer

1987 Chevy R10 project truck won't start

check the float on the carb is stuck shut not letting fuel in
2helpful
2answers

99 blazer, cranks but no start, pour gas in intake and it starts

well if its a 1999, it wont have a carb, it has fuel injection.take your fuel filter off and clean it or put a new on one, that should fix the problem. check your hoses too.
1helpful
1answer

Heeeelp! turns over but wont start. changed gas filter,cap,rotor.

Are you sure it is getting spark to the plugs? Did you check fuel pressure? It still may be getting some fuel but not enough. Is it fuel injected or car berated?
0helpful
1answer

Wont stay cranked

chek your injection nozzles they maybe clogged , also the fuel filter
0helpful
1answer

Engine will crank but will not turn over

Do this, take the top off the carb, being careful not to damage the gasket. Then take some carb cleaner and clean out the bowl and floats. Remove the needle valve and clean it out. Put it all back together and filling the bowl with carb cleaner. Start it with the starting fluid. Once you run the carb cleaner through it, it should start to run on it's own. Whatever you do don't shut it off for about 20-30 min unless you have to.
Not finding what you are looking for?

148 views

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...