I have a 1995 jeeo grand cherokee laredo 5.2 liter full tme four wheel drive i have chaged plugs wires fuel filter but when iam sitting at a traffic light and give it the gas pass 2 rpm it starts to buck if i give ithe gas gradule no engine light cna any one help
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
the first grand cherokee laredo was in 1992 . it was all jeep sports back then, the blocks are all the same .you will need to use some of the sensors from the old motor, the distributor and oil sending unit and temp sensor. will be no problem. if I can put a ford ranger motor in a mercury sable your swap is easier
Check to see if the fuel pump is running after it shuts down...could be a relay or the pump itself (overheating internally) Checked the fuel filter yet? Some crank sensors need to be shimmed. If it's too close to the flywheel even though you recently changed it, if it's too close to the wheel it can fail again. May not be the case but worth checking over. Also check the ceramic resistor on the left fender near the master cylinder if you have one. That too can cause problems.