Question about 2000 Hyundai Accent

1 Answer

Non starter hyundai will not start even after continually turning the starter motor but will start with a push almost straight away. no fault codes on ecu can you help?

Posted by on


1 Answer

  • Level 1:

    An expert who has achieved level 1.


    An expert who has answered 20 questions.


    An expert that hasĀ over 10 points.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 21 Answers

Try replacing starter motor.
Repeatedly cranking it over only heats the the starter motor , this then softens the solder and it gets thrown, then the starter requires more power from the battery leaving insufficient for the coil pack.
Push starting give the power to the coil pack .. and the engine runs

Posted on Sep 18, 2008


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

2 Answers

My car wont start right away and that I need to push it back or forth to get it started?

From your description it is definitely the starter motor sticking in the engaged position! Probably needs replacing, either the release spring is broken or needs lubricating!

Jan 11, 2015 | 2007 Hyundai Santa Fe Limited

1 Answer

Honda accord troubleshooting

check that the starter wires are not crossed or a brake in them that if grounding them out

Jan 28, 2014 | Cars & Trucks

1 Answer

Starter motor on c240 auto starts at times if like battery is flat u keep turning the key it then eventually starts no noise from starter motor or any thing and when it does start it starts perfectly

your starter is peobably going out brushes or solenoids wear out over time sounds like brushes inside the starter to me replace your starter

Jul 04, 2012 | Hyundai Cars & Trucks

1 Answer

Intermitten non starter. Happens every week or so. Starts after leaving for a while but no consistancy in length of time left. Once cut out while driving along a straight road with a slight hill. ...


I read your problem. What I would do, is check your 02 sensor, that is part of your emissions, and related to the cadillac converter, this would cause some cut outs now and then, and some hard starts. Some time garage mechanics can not find this code that comes up, especially if it comes and goes. Thanks Mike from fixya.

Sep 05, 2011 | Hyundai Genesis Cars & Trucks

1 Answer

Car doesnt want to start. all lights come on when in the on position however when I turn it to start nothing happens it dont even try to turn over it just clicks 2002 hyundai xg350

The starting system consists of:
  • starter motor
  • starter switch, part of the ignition switch
  • starter motor solenoid relay switch
  • starter solenoid
  • starter drive
When you turn your key to start your engine, it just clicks, right? If so, more than likely this is due to a bad battery. Even though your battery may appear to be fully charged, it may have a dead cell, or worse. If you get a jump, does the vehicle start? If so, replace your battery.

Possible sources of the problem if the engine does not crank or the relay clicks:
  1. Battery
  2. Starter motor
  3. Starter motor relay
  4. Ignition switch
  5. Damaged fuse
  6. Anti-theft system
  7. Circuitry

Mar 16, 2011 | Hyundai XG350 Cars & Trucks

2 Answers

Vauxhall calibra will not start ignition light

the flash indicates a code count the number of blinks usually a shot blink 1,2,3and so on followed by another series of blinks and it may even give 2 or more codes depending write them down and look the code up on line it could indicate that a door is open causing this issue **** as a sensor is not reading correctly a few other ideas to start with its just a matter of breaking it all down one section of area at a time to figure out the cause

Aug 29, 2009 | 1999 Chevrolet Silverado 1500

2 Answers

Intermitend starting fault ( Diesel )

Turn the key on and wait 10 seconds. see if that helps, let me know if you will please

May 29, 2009 | 2003 Hyundai Accent

Not finding what you are looking for?
2000 Hyundai Accent Logo

Related Topics:

218 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hyundai Experts


Level 3 Expert

77499 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8826 Answers

Are you a Hyundai Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides