Question about 1991 Honda Accord
Tips for a great answer:
Feb 07, 2014 | 1991 Honda Accord
Feb 03, 2011 | 1992 Honda Accord
Please see my tip at http://www.fixya.com/cars/r6223989-ignition_coil_doesn_t_spark . These are generic instructions--specific instructions are pasted below from Autozone.com. If you get stuck, please get back to me.
Use a test light to check for power to the coil on the black wire with a yellow stripe--see procedure below and other tests you can run. You will need a volt-ohm meter to run most of these tests.
The system used on 1990-95 Accords and 1989-95 fuel injected Preludes uses the distributor components to signal the engine computer. The ECU triggers the spark through the igniter unit and coil. This spark timing is controlled by the computer as an integrated function of the fuel management system. The distributor contains a crankshaft angle sensor and a No. 1 Cylinder Top Dead Center (TDC) sensor. Using these and other electrical inputs, the computer controls spark timing electrically.
1990-91 ACCORD Fig. Fig. 6: Terminal identification on 1990-91 Accords
See Figure 6
See Figure 16
Fig. Fig. 6: Terminal identification on 1990-91 Accords
Fig. Fig. 16: Coil terminal designation on 1990-91 Accords
Dec 27, 2010 | 1991 Honda Accord
Dec 03, 2010 | 1991 Honda Accord
Jun 06, 2010 | 1991 Honda Accord
Oct 14, 2009 | 1991 Honda Accord
Jun 13, 2009 | 1991 Honda Accord
Feb 05, 2009 | 1991 Honda Accord
Dec 29, 2008 | 1991 Honda Accord
20 people viewed this question
Usually answered in minutes!