Yellow indicator light on dash of 560 sec - 1991 Mercedes-Benz 560

Hi, your remote has probably lost its coding. If you have the owners manual check page 65 learning additional remotes. If not do the following 1. Plug in the 6 pin hopped coded plug to control unit under drivers seat. 2. Press unlock button twice to disarm. 3. Press learn button on hopped coded plug. this erases all pre learnt codes. The led on dash should start blinking once per sec. 4. Press learn button on hopped coded plug again. The led on dash remains on for 4 sec. and then starts blinking faster. Ensure to do step 5 within 25 sec. 5. Press any button thrice on your remote that has a problem. 6. In response led on dash remains on for 4 sec and then blinks once per sec.This indicates that the remote has been learnt. Hope this helps.

It's guaranteed to be within 36" (one meter) of the steering wheel, probably under the dash, probably VERY near the steering column, possibly behind a plastic panel you can remove with your fingers.

YELLOW MOTOR INDICATOR LIGHT MEANS CHECK ENGINE LIGHT HAVE VECHICLE CODE SCAN TO SEE WHAT CAUSING CHECK ENGINE LIGHT TO FLASH.

Hi, you cannot turn it off rather you have to reset it by following the instruction below...

1. Turn ignition switch off, remove service connector cover.
2. Connect (jump) the MES (Memory Erase Signal) connector (this is 2 pin connector wrapped on yellow plugged in the front of the under dash fuse box).
3. Turn ignition switch on.
4. SRS light will come on for 6 secs then go out, remove the jumper within 4 secs after the light goes out..
5. The SRS light will come on again, reconnect the jumper within 4 secs after the light has come on.
6. The SRS light will go off, remove the jumper with in 4 secs after the light has gone off.
7. The SRS light will blink 2 times indicating the memory is reset.
8. Turn the ignition switch to off and wait for 10 seconds.

It's an yellow warning indicator lamp. It lights when brake pads are weared. Now it's time to replace used brake pads!

It's an yellow warning indicator lamp. It lights when brake pads are weared. Now it's time to replace the used brake pads!

That light indicates that it is time to replace your air filter. After replacing the filter you will want to reset the lamp. On the air filter housing is a filter indicator. It is a small (2" round) cylinder with red, yellow and blue colors on it, as well as 2 wires. Push in the rubber yellow cap on top of the cylinder until you feel a snap and see the yellow plunger in the cylinder move. This should reset the light.
I hope this helps

Which symbol is it?

Fill up your tires and see if it goes away. It sounds more like a high beam indicator to me though.

yes what does it mean mine is green is that good