Question about 1994 Nissan Pickup

1 Answer

Vaccum leak under carborater

Cannot reach leak under carb.

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 962 Answers

You have to take the carburator off. Be sure to notice how you removed it. Make some marks to reinstall it properly.Pieces of masking tape with numbers or letters on the hoses and the place they go to are a good way.Check the gasket under the carburator. A good way to check when the truck is running is to spray the area with startng fluid.if the engine goes out the gasket is bad. Remove the whole gasket to the metal and replace it if nessesary.

Posted on Nov 02, 2008


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

1963ford fairlane 260v8 stalls when shift into drive or reverse.

Sound like a fuel problem but wth it idling listen for air hissing may be a vaccum leak if no hissing i would probably rebuild carb but try afuel filter also check for fuel leak around carb

Sep 29, 2014 | Ford Fairlane Cars & Trucks

1 Answer

Vaccum leak in 2004 pontiac bonneville

spray carb cleaner around the engine when the engine is cold to see where the engine speed changes the intake gasket is a common part to look at

Oct 06, 2012 | 2004 Pontiac Bonneville

1 Answer

I have a 1989 ford econoline with a straight six engine. It runs great when i get going, but when i come to a stop sign it dies. It also dies after about a minute when it is idling. Can anyone help. Im...

check for a vaccum leak. you can use carb cleaner around the side of the carb and around vaccum lines. if it lowers the idle or kills it `its a vaccum issue easily fixed. could also be low quality fule try running a carb/ fuel injector cleaner through your fuel. if none of these work then id goto a more expensive solution.

Jan 31, 2011 | 1989 Ford Econoline

2 Answers

Installed new fuel pump car still won;t start

Check Filter inside Carb.. Also Under Beside the Gaz Tank ..Check unplug Gaz line beside Carb and start ..See if gaz came.. if yes
check filter inside Carb....Check wile pressing gaz pedal see if gaz spay . Make Shure The Primer Work Find.. Then Chek For Vaccum lost Vaccum Are Important For System Performance.. Some Logic Board work with Vaccum Exemple Boddy Trothle.. Electric Choke... Cruse Control Idle Control and Distributor Advance..
Good Luck

Oct 06, 2010 | Honda Accord Cars & Trucks

1 Answer

1995 firebird sounds like bad vaccum leak blowing black soot and smells horrible what could be the problem its coming from the top of the engine under the hood.

could be exactly what u said.. a bad vacuum leak. spray a non flammable liquid in area of noise and see if u can cause an rpm change. suggest a throttle body/carb cleaner spray to perform test.

Nov 15, 2009 | 1995 Pontiac Firebird

1 Answer

Engine idles good until i press the brake ,did not see a pcv valve coming from brake booster to carb.

pcv valve does not go from brake booster too carb!!
it goes from intake too valve cover,
but it does sound like you have a vaccume problem check for a vaccume leak!!!

Jun 05, 2009 | 1994 GMC Sierra

1 Answer

Carborater gets stuck on my 1989 jeep cherokee pioneer

The 1989 Jeep did not come with a Carb it was throttle body injected and the motor should be a 4.0. let us know what motor it is.

Feb 28, 2009 | 1989 Jeep Cherokee

1 Answer

Wont start

most vacuum leaks are in hoses that are disconnected or have holes in them you can also take a bottle of water and spray it along the side of the intake and base of the carborater if the motor bogs or you here it **** the water in you have found you leak but it can be a leak under the intake and that is a bigger problem to find

Jun 12, 2008 | 1985 Chevrolet Monte Carlo

Not finding what you are looking for?
1994 Nissan Pickup Logo

Related Topics:

39 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts


Level 3 Expert

77499 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

726 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides